Separate names with a comma.
Have thought about it and if it's something you can use, consider it yours Jeff. Have your # and I'll call you tomorrow.
OK then, But look… I’m just trying to verify some info I saw on another site. It’s not like I can just run down to the friendly local NAPA...
Guys, I found a thread on the Nostalgia Funny Car site where someone gave the bolt hole spacing for early and late TFX pans. According to him...
Sorry for the typos. qith was supposed to be width, at tape was supposed to be a tape and maybr was supposed to be maybe. I'm old and half blind...
Ok, now I measured a bit differently so I'll explain as best I can. Looking from the top down and starting at the front, I get approximately 3...
I'll get off my semi lazy butt tomorrow and get ALL the dimensions (exact length, width, etc.) along with the approximate spacing of the bolt...
What I have would be for a 92 then. It's a tad over 1" wider than std Hemi. Thanks for the additional info.
To ta455: YOU ARE THE MAN!!!!!!!!!!!!!!!!! Those are exactly the photos I needed to verify my pan is what i thought it might be. Can't...
Really can't give an answer on when but sure hope you list your old KB for sale here if you upgrade. :D
A clarification is in order. What I'm trying to say is if one were to look down on the block side and measure between the flanges/rails on a...
I have an oil pan made by Moroso that is definately not std late Hemi because the mounting flange is way too wide. Would like to sell this but I...
Been following this question closely as I'm knee deep in something along the same lines. Noticed a picture on the KBRE facebook page showing an...
Thats interesting... I'm currently putting together a 505 big block mopar and looking around for an altered chassis. Love FEDs but dragsters are...
