521 BAE w AJ Muscleheads. New Rotating assembly, Manton Rockers long or short block

This is the motor I have been building for my personal car. This motor will go 5.40's in TAFC with newer heads and the right top half and tune up. I built it where I could lower the compression to run dial in/index classes or change the gasket to get into heads up trim. I'm confident it could run 3.60's-3.70's in FC Chaos outlaw trim without leaning it or revving over 9500 (that was my plan). My original plan was to run TAFC and be able to turn 10,500 with it, so it can handle that if you need to.

521 BAE Short or Long block FOR SALE

• .500 Short deck BAE Billet block. Never been windowed or saddled. No. 2 main cap replaced when I got it and 2 sleeves replaced. Will have fresh Rottler diamond hone on it.
• NEW Winberg billet 4.150 Splined (PSI) Crank
• NEW GRP Rods w L-19 Bolts
• NEW JE Pistons, NEW wrist pins, NEW Buttons
• NEW Total Seal ring package
• NEW Williams Dry Sump pan
• NEW Custom grind HMS 60 mm cam
• NEW Manton Billet Rocker Assembly
• NEW Manton Tool Steel pushrods
• NEW Bearings and Gaskets througout
• NEW RCD Front Cover
• NEW Pump Extension
• NEW Hub
• Jesel .904 lifters with 25 runs
• System 1 Dry Sump Pump
• Dunn Mag Drive
• AJ Stage 1 Muscleheads. Comperable to BAE 6 heads. Low run and fresh. Just gone through. 8 new exhaust valves included as spares
• BAE Mag intake for short deck/screw. In very good condition
• BAE Mag Valve Covers powder coated black. With the Wiggins clamshell disconnect on burndown tubes.
• RCD Idler assembly

$32,450 for above parts as assembled long block. Will put new head gaskets to suit your desired compression ratio, assembled with spec sheet. $30,950 unassembled

$19,950 for above as short block. Less heads, rockers, push rods, valve covers, intake, mag drive. $18950 unassembled.

Can sell complete running engine from injector to pan with a Good PSI D rotor, fuel system and MSD 44 Ignition system. Also can supply complete drive train with Quickdrive, bellhousing, Chance NXS Converter, B&J 3 or 2 speed.

Will Hanna
979.415.4959 (no calls or texts after 9 p.m. CST)
will.hanna@insidetopalcohol.com

 

open to reasonable offers