Separate names with a comma.
Bob, I measure the roller with a micrometer every few races, and if the dimension varies more that .001" (measuring in 4 or 5 places), I don't use...
Is the blower fresh and making good boost? How fast are you spinning it, maybe a combination of too much OD and a loose blower is causing it to...
I didn't know about these, I assume they're the CB 1512 M variety? We use the harder V bearings. We had a similar experience with the same brand...
I like Velasco
Russ; A few things that could help: A single super mag 3 is normally run at 38 degrees with these types of heads, that will help a lot on the...
I haven't had any problems. The only thing I would suggest is to make sure the oil return holes/slots in the lifter galley are large enough so...
Sounds like you have a combination of problems. You would have to list your entire combination so we could see if anything sticks out. Have you...
First thing you should do is talk to someone that has an L&T to confirm that you have the right base height. If that is correct, I don't think...
Awesome performance all weekend!
I'm not familiar with the chevy, but with our hemi we were running 38 degrees with a single Super Mag 3, and dropped down to 27 or 28 with the 44...
I'll be in Vegas next week, is it possible that someone will have some of these decals there?
Make the patch fit tight, and use jackscrews between the mains (in the section you are welding) to help prevent the block from "pulling" when the...
The brand of head gaskets hasn't really been an issue for me, but then we only run a roots blower. By the way, I measured the grooves in our...
Assuming you have the stainless wires pressed into the grooves in your heads, make sure the receiving grooves in your sleeves are wide enough to...
Tom, is this stuff fire resistant or fireproof? IHRA stipulates that fireproof breather hoses have to be used this year.
Sorry, a bit of bad grammar there. If you're talking about a hemi, I find that .0040 to .0045 on the mains is good, any more that and you might...
If you're talking about a hemi, I find that .0040 to .0045 on the mains is good, any more that and you might run into blackening issues when you...
We run an integrated show (fc vs dragster) in Mission every year at the Canadian open, and it is a lot of fun. Right now, the fc's get a head...
The warpage is an un-desirable effect of the extreme heat and pressure generated by the horsepower of the motor and the load the clutch carries....
I saw the Banks turbo dragster run numerous times. The problem was that the boost wasn't up high enough when it left, but 60 feet out, the turbo...
