Separate names with a comma.
Oh, and young Ashley Bart (TAD) will be there too.
I've also heard, but can't confirm: Greg Tacke (TAD) Greg Sereda (TAD) Jordan Pawluk (TAFC) Bill Edwards (TAD) - maybe Greg Hunter (TAFC)...
Very cool, way to go guys!
I like my fuel pressure to be in the 145 to 150 range; if you are running higher than that, make sure your pump saver valve is set up so it won't...
Nice run in the final Dennis, good job.
Very sad news today, our deepest condolences.
I switched from Brooks to GRP, just so there was no doubt.
We just use the rubber injector hoses; the newer ones are rated to 1000 psi, even the 500 psi versions will work. We run steel brake line inside...
I degree the cam to where the cam card says the intake valve opens (@.050 lift), for example mine would be degreed at 35 degrees BTDC. I thought...
We had the same thing happen a few years ago with our roots funny car, and it ended up being the fuel shutoff closing on its own. Wrapped a piece...
Holy Crap!
I prefer the Sitko mag drives, but then, I might be a little biased (lol). Seriously though, we have never broken a part on them, very reliable.
Not sure if there's a difference with nitro, but I won't run less than .032 on the top ring, any tighter and your ring will butt up, wreck your...
You can get the V bearings from BAE, and I think Robert Reehl has them too. His number is on the ad on the ITA page.
Congratulations Rob and Julie Ken, Nathan & Troy Sitko
If you have an all-out racing deal (retro fit blower, titanium valves, good bottom end, 44 amp ignition), you should be able to run it to 9000 or...
Sorry guys, I meant the upper as well. I'm upside down most days anyway.
I always make my own, but someone must make them. Call RCD or Waterman, they would know.
The lower bearing looks like it rubbing, since it is not likely the oil, it could be the start of the breakdown of the bearing material. Since...
Mike, I have found that no matter what I do, the Arias pistons will crack in that area within about 10 runs. We run J&E pistons now, and haven't...
