Separate names with a comma.
Sometimes bigger motors don't make any more power than the smaller cubic inch because the blower has to fill a bigger volume, so if the blower...
The ones I use are either of the following: Transmission Seal (rear) CR 13920 Transmission Seal (rear) National 472658
You're always better with a dry sump deal. With the dry sump, you always have a large reservoir of oil to draw from, and the crank is not...
It should run mid to high sixes, as long as you can hook it up. The 4.88 gear sounds awfully stout, you didn't mention what the low gear in the...
Some cylinders run hotter than others, and depending where the lean spot is, the heat won't show on the plug. I have found that our plugs can...
I agree that the rod bearing clearance starts out at .0065 to .007 with new rods, but if you've ever measured them again after only one or two...
My dad (George Sitko) makes one which we use all the time. I think they're about 40 bucks, call him at 562-243-0482.
Also make sure your idler is supported so it stays straight and true. Use either an RCD support or make your own so the idler pulley doesn't get...
Back when everyone was running high compression, our TAD had 12.3 compression, the intake valve had .125 clearance to the pocket, the exhaust...
I don't know about a gas blower, but from what I have seen with the alky blowers, they usually have .008 inches to the front of the case, .012 at...
lighting Not that I'm going on a witch hunt here, but one of the things that scare me the most is bad lighting and racing at night. Often a race...
I've run off the end of both the old Calgary track (Shepherd Raceway), and the newer one (Race City Speedway), luckily both have lots of grassy...
Sorry to hear that Bunny is back in the hospital, best wishes for a full recovery!
My experience is that if you tip the spindles more than 10 degrees back, you'll have that wheel flopping thing happen when you back up.
I think everyone should use their real name, if they want a nick name they can display that too. Keeps everyone more accountable for what they say.
I liked running the Whipple, you pretty well run it the same overdrive as a roots, so you can use the 14 mm belts if you want. It performed very...
If you have an older style ignition box, it might be set up to fire only after a certain rpm (I think it is 400 rpm). Your blower starter might...
I don't put anything under .320 in for the next run, I consider .290 to be a dead player.
The steel guard rails scare me too, we shouldn't be running them, and NHRA shouldn't sanction the tracks.
We owe you one next year Greg, watch your back! :D
