Separate names with a comma.
Heres a mathematical question for the resident gurus. If I have a Hemi with 10.4 comp and 55lbs boost, how much can I raise the static comp with a...
We normally pull the flywheel up dry (no oil, no locktite) then pull the bolts out one at a time, red locktite them and torque to 100ft/lbs. I now...
What is the current trend with Hemi flywheel bolts? Torque numbers, how many runs before replacing, how many runs before you need to recheck...
2700lb screw blown door car. always shows more tyre temp on left rear on launch. i thought this was showing more slip on left side than right side...
I'm about to order a new helmet and want to know which is the best speaker/mike set up to use. (want to get them factory fitted) Any opinions ?...
Lifting Been doing it for years with no dramas(1/2" plate,4 bolts)
Did you still use the trans brake with the linelock ?
Is there any real benefit from running a crank support geardrive on my Hemi? 511 PSI Fathead deal, sees 10,000 regurlarly without one. Thanks Murray
You will need to grind some clearance into the case itself but its not a big deal. I'm using billet cases now and gear life is exceptional
Any one using a combination of 3 lock up levers and 3 normal? General concensus here is that it wont work so you have to use a 2 and 4 combo!
Third Member I've done this before, 9" to 9.5" then up to 10" gears. All you need to do is grind a little out of the face of the housing at the...
Roger Way Try rwrtopfuel@windstream.net or look for his ads on Racing Junk under Top Fuel
Rod length I run a 7.306 rod with a 050 gasket in the same combo if that helps. That wasn't the crank on E Bay last week was it ?
Spot on,it still has the Dana
Robert, yes I knew it was a Swindhal car, just couldn't remember who drove it originally. It was raced in NZ by Garth Hogan before being shipped...
Don't know if this is the right spot to ask or not. Anyone know anything about the Grizzly Adams sponsored Fueller, circa 1982 ish. A picture...
Graham, i've only gone 6.08 on them so far but John Zappia! regular 5.80's on M/T's. Aussie Doorslammer trim. I love them. Murray
I know they aren't a Bryant but do they hold up ok or not, looking at putting a low dollar deal together for a friend of mine and was unsure...
Doug, the TFX and the Brad are both very similar in the routing of the oil passages (unlike the KB) which is why I cant work out where its all...
Its got a dry sump, 20 litres of oil, pressure comes of the manifold on the oil pump. Will tear it down later in the week and look into the roll...
