Separate names with a comma.
Maybe this is a dumb question, but here goes.... Why are carbon/carbon clutches not more prevalent in drag racing? Surely it can't just be the...
What is the out and back discharge angle of legal TFFC header pipes these days? Is this regulated or not? Thanks.
Roughly how many gpm of nitro would a current A/Fuel dragster run? Thanks.
I know the world has moved now to 5.00, 5.300, 5.500 bore spacing, and no doubt someone in the world has probably moved on to like 5.750 or 6.00....
Has anyone ever tried a 477 deal (or close) in a blown P/M? Thinking around 4.500 bore and 3.750 stroke, and raise the rpm's. How did it work...
Has anyone tried thermal barrier coatings in a blown alcohol deal? Runners, valves, crown, chamber, etc. What were your thoughts or...
Has anyone out there been involved with doing CFD analysis modeling work with the PSI screws? Would like to talk to you offline if you would not...
Roots or screw. Has anyone ever tried tossing a portion of the hat fuel "up" into the airstream in order to give it a better chance to mix with...
It does not have to be pretty or functional. Looking for an 11.2" (or taller) deck dead block for mockup. What have you got? TOLeneregy@look.ca
Have to order some pumps in the next little bit. How does Waterman stack up against Rage? Thanks.
For those of you with EFI meth systems (or MFI) what exactly are you doing in terms of purging your fuel systems for storage between usages? I'm...
Dumb question...... What actually causes crank hub galling and metal transfer? Is it because the hub is trying to wobble up and down on the nose...
Has this been tried before? Any advantage or disadvantage versus a 3-speed? Quarter mile stuff. Thanks.
Is there much advantage to the RCD threaded hub setup that uses the big locking nut to clamp the bottom pulley in place? Or would the PSI pulley...
I'm curious about something, and would appreciate anyone chiming in either online or offline. With a "screw" (take your pick, Whipple, C, D,...
Can a person run non-vented nozzles in a supercharger hat? Any real problems with doing this? Trying to cut down the minimum idle air leakage...
Has anyone tried the MK16 CG/DMPE front load screw injector hat with the big blades? What did you think? If not the 16 how about the MK12 with...
Does anyone have some approximate flow numbers for the NRE heads that they are willing to share? Either the PM head or the TAD/FC head. Thanks.
http://www.dragracingonline.com/agent1320/2015/1320-xvii_1-54.html Saw this and wondered to myself, is there any benefit to this in a PM door...
Are there any real rules of thumb for the length and diameter of a zoomie primary tube on a supercharged motor? For instance, shorter for higher...