Separate names with a comma.
I will have 55 gallon drums of 99.5% for sale this spring...motorsports sales only...looking for a few A-fuel teams as customers...call for...
Looking for a few used 14MM GT pulleys - with .320" offset Would like 27 - 28 - 29 tooth if ya have any laying around... Thanks, Scott Gaulter...
New 74 tooth aluminum - $150.00 Used 77 tooth magnesium - $100.00 New 81 tooth aluminum - $150.00 Or make reasonable offer on all 3 Plus UPS...
This is a KB 4.500-4.700" sleeve puller that was machined down to 3.980" for 4.00" or slightly oversize bore. Comes with an adapter to fit most...
I have 8 new 11/32" and 2 new 3/8" lash locks that I got from Manton several years ago....now manufactured by Wesco. The 11/32" are 10 degree...
Nice used Dunn 4.3" offset Magneto drive that fits a 426 style hemi - with upgraded PSI shaft & gear. Comes with support block and bracket that...
All new 413 cubic inch TFX nostalgia nitro short block built in 2013 as a spare. I have never run this engine, just stored in the shop on an...
Funny car/altered puke tank. A little over 2 gallon capacity. Let us know where you want the the entry tubes and drain plug located to allow...
New 125" chassis just finished. Cage inside width at shoulder is 20.75". Late model Hemi chromoly rear motor plate (BBC or others available) is...
There are many threads here on ITA regarding MSD 44 amp mags.....but my problem might be unique... Bought 2 new 44 amp mags, FIE coils and...
Just wondering what clearance I should have between the the landing on the button and oil ring? This button is just below the oil ring and...
This has probably been discussed here before....does anyone have any info on Fel Pro rear main seals? I show 2 part numbers - #2947 is...
I had several small cracks on welds in an oil pan..on the baffles As you can see in the photos - the weld cracks when it cools....I know this is a...
For any newbies on this site, the Spring 2018 issue of Nitro Madness Magazine will mail around February 20th. It's a free subscription and I only...
I bought a set of new front wheels and a degree ring from Brad Terry in CA in October 2017....and wheels were missing the wheel bearing...
I recently developed a neat way to keep all of your racing receipts, specifications, trailer maintenance, etc. using these tabs in a 3 ring...
Radar had a light rub with the wall at Havana last weekend....scratched up the outer beadlock ring on a M/T rear wheel...sanded and...
I have 2 RCD 6.375" diameter degree rings - both are for center flange pulley (offset)...one new = $100.00 and one used = $50.00 (outside degree...