Separate names with a comma.
First time user of Bruno, ready to go, hooked everything up, air on, pressed brake button. Air exhausts from brake unit, is this normal whilst...
Is Scott Moore from Mooresville NC safe to buy off - I live on the otherside of the planet.
I bought some spares from a guy back in April 2011 he advised he lived at If any body knows him could you ask what is happening, as I live...
Is there a Hemi pattern bell housing to Bruno Drive out there?
Who makes a 1 piece unit that runs 250 psi and 200 psi for shift and transbrake via same bottle? Trying to save running 2 separate regulators.
What effect will dropping the lift at cam from .465 down to .440? E.G. Will it allow engine to rev easier. Will it hurt performance....
Why are the mounting brackets on a custom fabricated rear-end parallel to the wheels when nearly all rear engine dragster chassis' angle in from...
I read some of you are experiencing issues with stability of Hoosiers Mickey Thompson or Hoosier 33 x 17 x 15 Blown Dragster
I have just taken the damper off and found the 2 keys are headed to shear mode. BBC snout on the crank Damper is steel centre with aluminium...
I have a rear pick up in my sump, and was thinking about installing another one, but in the centre. The line to the single entry, external...
hi what is the back lash for a 9" 3.89 gear set. for blown red. not pro-gears. ex nascar. bought these off ebay
I'm in the process of constructing a manifold for my engine with 2" runners. Am concerned that a vee on the bottom is too directional. (unable to...
Would 3 bolts each side, between the ports, be adequate to hold a blower manifold on to the heads.
What is the minimum ring land to valve pocket clearance when milling a piston.
What is a good and reasonably safe compression ratio for a blown alky 4.1 stoke x 4.440 bore dragster motor with 16/71 H-H @ 36% and hemi heads....
Chamber design: half round or fig 8 chamber. I see some hemi heads are coming out with the figure 8 design for the chamber, is there any...
I note there are a lot of s/h bruno units for sale, why is this. A lot have lencos attached too ??? Are they not up to it for a blown alky...
Why is it some billet cranks are fully counterweighted and some aren't. Blown alky application.
Rod side clearance I have a new set of Ali rods, 1" wide at b/e, I need to remove .035 to .040" do I remove from one side only.
