Separate names with a comma.
Some people close off the lifter valley in an effort to make more power at the crank, since the rotating assembly isn't beating through the oil....
Seems like main cap girdles were once popular with BBC guys, anyone out there using them, making them or are some still laying around? Would...
Are magneto clamps and fuel pump clamps the same thing, in other words would they exchange with each other?
We are trying to get on a waterbrake dyno that has never run a setup like ours, about 1700 HP/1500 ft lbs. I'm trying to get a feel for what we...
When you see the "slow mo" on NHRA tv events, how many frames per second is that?
Distributor gear roll pin What kind of things do you do to keep these from breaking or coming out? Whats wrong when they continue to work...
Where are the bigger dynos located around the country that can handle a strong blown alcohol V8? These are the ones I can think of: -Mandolini...
What are all the main bearing sizes used over the years in blown V8's? Didn't Arias use Ford and Cadillac? What were those diameters? A BBC is...
Water or foreign debris in the alcohol can make the fuel bad, is there anything else that can make it bad? We are suspicious of our fuel, what...
How much can your rod bearings widen before you say its lean enough? .005"?
What are all the reasons a roots blower belt breaks? -detonation -too tight -can a belt be too old? What have you experienced?
Fuel System doesn't react to main pill changes I am looking for ideas. I have a proven blown alky fuel system that suddenly, without any known...
Do you have any tricks to get sheetmetal parts disassembled after they have been "glued" together with silicone, prybars, chisels, etc. just...
We run blown BBC's and mostly have offset rear mag drives but I'm slowing getting switched over to front mag drives. Does anyone sell premade to...
When comparing the crank align bore and the hole in the back of the bellhousing, what is an acceptable tolerance? Also, what are some different...
I have a vinyl decal auto-body shop right next door to me and was thinking of having them make me some butterfly decals like the lettering we...
Does anyone run aluminum brake discs? Have they been tried with hard coat anodizing and/or cryogenically treating them? What are the pros...
I am looking for info on the different oil pan bolt patterns offered for BBC. Moroso lists the following info in oil pan descriptions, are...
For years I have fought our ring compressor with dykes rings. Its like the ring slides up in the ring land vs. compressing. Have you had this...
Where did these originate? http://www.goodvibesracing.com/bases&drives.htm M-35595 Were they bases for point distributors?
