Separate names with a comma.
2 step anyone ever tried with a whipple/lencodrive?
do you have to support the rear of a 3 speed lencodrive with an aluminium bellhousing in a dragster?
Who makes the best alcohol dragster wings? Carbon or aluminium? Which lasts longer?
rear wing How is the correct way to measure the wing angle and what to use to measure it?
Which is better, pros and cons, or use both?
Has anyone used one of these blocks in a blown alcohol application, in a Hemi configuration?
I have a 2 speed 2005 model lencodrive that worked for 2 runs then on the step had no drive, big over rev. Thought it may have not selected...
Who sells the best converter for a lencodrive/dragster ?
Is anyone using a 2 step for startline rpm with a lencodrive and roots blower?
wouldnt the heat in the trans be relative to the converter selection? If the converter was too loose, that would cause the motor to drive thru it...
Pros and cons of both? Lencodrive deal, 481 cubic inch Hemi, outlaw funnycar. 6.50 et cutoff
I have a Hilborne#4 pump and an Enderle 1100, Which is a better fuel pump?
We ran a merlin headed deal and used Champion V59C with good results. 440 cube, standard 8/71, 2300 lb, 7.18 @ 185.
I have sourced a 3.95 inch stroke crank and am wondering if this will suffice? Also what static compression to start with?
What is the best engine combo for a lencodrive application,2400 lb funnycar? Big bore, Small Stroke? I have 4.31 bore 4.5 stroke Brad 3 heads...
Where is the best place to get a custom length solid driveshaft from?
We run an outlaw class that permits such devices
Who makes a progressive throttle controller for stage rpm and launch control to use with a lencodrive?
B&j John Zappia has run 5.967 in Top Doorslammer and uses a B&J. He thinks they are the trans to use.
John Zappia has just run a 5.96@ 239mph at West Sydney
