Separate names with a comma.
Whats everybody using for wires on a 44 mag,how often your changing them?
just got my stainless fittings today from applied racing components out of fl,75.00 to the door,thanks for all who replyed!
thanks mike!
i tried those,the cap threads are different, i was hoping to get by with those,thanks!
Wheres the best source for Stainless or a cheaper brass 3/16 egt compression fittings for a data logger? thanks for any help!
yes its the ultra case,so your saying that thats where the mount or bracket will attach to with the proper bolt.
anybody know who makes one? thanks!!
Thanks for the tip!
no crank trigger is being used
Is it possible for the msd 8973 box have the timing come in and out as you were going down track when you are pulling it out by rpm at launch and...
what are the real world flow # for a new or fresh enderle 990?
who is the best to have a fuel system flowed?
what is the most mim. clearance you can run at the bottom of the cylinder for rod clearance with alum rod,thinks!
if it was a lean cond,wouldnt it throw flames or blow the burst panel out?
its a laying down type,power picks up falls flate ,surges like that all the way down track after the 60,rear gear is a 389,180 gear 2spd...
what are some causes of engine surging going down track,leaves line good and hard,motor surges after 60 ft, chevy with 14 degree heads and 1471...
thanks!!!!!!!!!!
anybody have it!
You Have Jerrys #,thanks!
my motor is balanced with the brook rods,i havent had any problems with them,i have also ran the grps on a nos motor with only 1 braking in 3...
