Separate names with a comma.
I tried sending you a PM. Your inbox is full. Sir. I am sending a message in regards to the following reply....
http://www.tripletraceproducts.com/
PM Sent. Thankyou all.
I am requesting a little help / guidance regarding an cylinder head service tool tray setup. Basically, I want to hear from anyone who is using...
Hi Everyone. As some of you may remember, I was building a EFI 481x combo. I have decided to scrap this, and go with an EFI Hemi combo, using...
I have been doing a bit of research on which forged block to use for a Hemi application (blown alcohol). I have noticed KB now make a forged...
Will this work for oil contaminated with nitro? Andrew.
Harold Martin runs a Nitrous powered entry if I am correct?
As for the Mech/Elec Injection setups, I do understand that there are a lot of proven tune ups in Mechanical state. However, I do wish to run...
I am planning to run top feed EFI injectors. Andrew.
I do not have an pic of the actual manifold, but here is a link to one. http://www.alanjohnson.com/images/pm_2.jpg The car will weigh around...
I have a 481x engine, complete from manifold to sump. I am accumulating parts for this engine to run it with a PSI 'D' Rotor blower. Instead...
