Separate names with a comma.
I would lean towards a cam with a wider center....say 114....If you didnt want to spend the money the 110 would work though. Make sure you have...
Sorry.....That sounded kinda Dr. Seuss.
rods and pins Use a good alum rod if you can. Heavy wall pins are a plus. Agree about the O-Ring. Its a must.
What size stroke you plan on running? I have run a 9.8 for years with no problems. Just make sure you run good rods and heavy pins. I prefer GRP...
strips Perhaps I was misleading when I said to "Leave them out". I spoke with Rich at SSi. He was saying that valley strips are good for fuel...
Has anyone ever had a 14 71 HH rotor with "valley strips" in it? I have a 14/71 with Kobelco HH rotors with valley strips. Was told to leave them...
Update.....Blown Intake gasket Blower was fine. Pulled the intake off today and the intake gasket for cyl.# 1 and #3 were leaking at the bottom....
I ran my 4.600 Merlin 3 at 25# of boost for 2 races. It cracked 3 cylinders and split the middle bolt hole in half. Bought another one and same...
Thats funny about the 40 over bit.....I tried 40 over once and it leaned it out so bad I broke a wrist pin. Just could not get enough fuel to it....
Whites Only I checked it out and the rotors have the white strips only. Blower turns pretty easily by hand. Dont know alot about...
SSI B Rotor Just found out I have an old B Rotor. Guess Ill turn up what Ive got and see what happens. Thanks for all the advice.
Thanks for all the opinions. One last question. What would be the advantage to an 18/71 Kobelco vs. a 14/71 Superman or M4? Would it being bigger...
Heads Heads are indeed very good. 18 degree Chiefs that flow 540@ .900. Not so concerned about total boost as I am total HP. I am leaning...
I run a Automatic Pro Mod and I am limited to a roots blower. I am also on a budget so a $10K+ blower is not in my future. I am currently running...
Ya never know what somebody has hid under the bed.....lmao
How much cfm does a PSI D rotor charger move? Is there a chart somewhere?
Centrally Located Pie Not sure on the plenum question. However, I had a BBC sheet metal intake fabbed up from Self Racing in Oklahoma and had the...
sbc heads Are you referring to a std 24 degree sbc vortec? If so, The geometry is the same as far as I know.
Self Racing Call Kevin Self 580-924-5866. He built mine and it is awesome. Randy:cool:
Just my 2 cents I used to run a cast 4.25 stroke Chinese crank in my 565 BBC til I switched it out to a Forged Ohio since I wanted to go above...
