Separate names with a comma.
Just curious, but what kind of flow numbers do you have? I would start with a 4.10 gear and see where you are at In the traps.
I thought that shimming the springs .050" from coil bind helped with the unloading of the spring as it approached valve float as well as the...
How does trimming the end of the spring affect the spring pressure and spring harmonics? Obviously it doesnt break the tips off anymore.
I read somewhere that increasing the gap of the second ring allows for less pressure build up between the top and second rings,reducing flutter of...
What do you mean by linear? Like if the line has any abrupt changes, you have an issue somewhere?
Did you hone the bore before installing the A&C rings?
Thanks for the reply, does they type of coolant matter if it is oil based or water based for cutting the floaters? I recalled a post of yours...
Thanks for the reply Mr. Canter, the .005" wobble, you are referring to the clutch discs correct? How much should I be cutting on the discs?
I was recently playing around with our clutch disks and floaters. I was able to make our flywheel machine able to cut the floaters. I am worried...
The passage in the front and the middle of the blower create a vortex as they enter into the manifold, if you over fuel the hat, the vortex will...
Is it common to run compression that low with a vintage nitro engine?
I think if you are looking to be maintenance friendly, you are going the wrong way. If I were in your shoes I would have kept the sbc and the...
What about taking timing away or adding fuel? Seems either way one would mellow your setup some.
Is the valve a normally open or normally closed valve? I like to run a normally closed valve and open it up at the hit of the throttle, because...
The two in the back of the hat are to replace the front two nozzles. Traditionally, these two nozzles have checks in them in an effort to keep the...
Can't go wrong with a Mike Bos car.
I would think that it is a fuel related issues because you have different fuel requirements revving the engine to 5500 with no load and then...
What kind of times did you run and how heavy was the car? Clutch or converter?
Nice explanation, since you are talking cylinder pressure and exhaust valve opening in a blown alky combination, is it possible if you open the...
As you Widen the lobe seperation, say going from the 114 to the 116 it changes your valve events and will also decrease the amount of overlap that...
