Separate names with a comma.
The carbon fiber ones are working great. There were some problems when they first came out but all that is now fixed
I think single wheelies are less complicated. I would stay away from Ti because the welds will crack. Ti has to be welded in a chamber filled with...
I think the most critical torque is on the rod bolts. You can probably be ok at 5% over but dangerous at 5% under. That’s not based on and...
You get what you pay for $$$ but how much do you spend on that motor.
Usually the manufacturer. I know some of the tool trucks have a device for checking them.
I think a lot depends on what you are going to torque. For things like rocker arm stands the smaller SnapOn digital is great. For rods and mains...
I have always installed the probes 2 to 2.5” from the head. And closer than 1.5” will reduce the life of the probe. The tip of the probe should be...
They either flat line or real low and look like noise. Never seen one fail and read a high temp. It would be unusual for all of them to fail and...
You should find out why your EGTs are that high before you lean it out. Could be the position of the EGTs are too close to the head or your...
What I try for is for the pump pressure at 8000 rpm to be 125 to 135 lbs. You should be balancing your port nozzles based on spark plug readings....
But what he is seeing is normal
That is pretty normal. The reason the port reads lower than the hat is that the port flow goes through a check valve. What ever the spring...
24-25 degrees is still good. You can go to 26 if you put in more fuel and are willing to be on the edge.
I agree with Mike Kosky, you need a large supply line from the tank to the pump. Also need larger tank vent. Don’t know if that will fix your...
You can also drive the mag off the front of the motor but that cost $$ to do but works well.
Well you didn’t say that you had bought everything as a engineered kit but worth checking anyhow. Is all this on a Hemi or what? All the hemis run...
On a high helix blower the exiting air/fuel comes out at a 45 degree angle towards the front. So unless the blower is set back the air has to make...
A lot of cars run either a hose or use a frame tube to connect to a puke tank in the middle of the trunk with a vent pipe that comes up through...
Look and see what your fuel pressure is at idle and make sure your port nozzle Check Valve is set higher than the fuel pressure. Normally a port...
In either Jetsize or the preferred more accurate Alky Pro the only see what you enter. So yes if you put zeros what you listed then if you have a...
