Separate names with a comma.
Timing will remain the same. Both the 12 and 44 have circuits to keep the timing stable during the rpm range. Only the non MSD mags vary timing...
May I ask what you are trying to compute flow for? I have charts that I can give you on GPM thru all the jet sizes
That’s what I said above
I have been told by a close friend that had a PSI that they worked better 40-50% than lower ODs
It depends. You can use the pump loop to bleed off pressure at idle if it is too high or you can measure the pump outlet pressure a idle and put...
To add to Will. The extra HP and heat generated which heats up the incoming air charge which raises the DA and causes power loss. If you get a...
It is not voltage that burns up solenoids it is high amp flow Every time the contacts open or close the high current flow arcs the contacts. If...
Here are a whole bunch of videos by Chance https://www.racingconverters.com/tech-videos/
See if this helps [MEDIA]
I called Brad Penn a few months ago and talked to them. They say there is no change in the oil formula.
I think you would be wasting your money. Today’s blowers have different rotors, different cases and different top and bottom openings. You could...
Add .35 gpm of fuel for every pound of boost increase
Have you tried taking off the line on the pump that runs to the BV and check to see if your fuel shutoff is backwards
Have you checked that the pump shaft from the cam is turning. Sometimes they break
The reason the engine speeds up and shuts off and is hard to start is because itwent lean right before it ran out of fuel. Is somebodyvsquirting...
That five degree retard is invisible if you time the mag or the crank trigger with a timing light. Do not compensate for it. The pictures of your...
Motorworx if the plug only has a small crescent that is gray/black and the rest I sunburned I would lean it out by five main jet sizes and look at...
What plugs are you using?
How do you know the fuel system is only a little rich. Sounds like it maybe very rich. What does a new set of plugs look like after one run....
You can do it either way. Normally you don’t want more than two items getting RPM off the gray wire on the Grid because it loads it down.
