Separate names with a comma.
Thanks Will Ill look on Welds site thanks mate see you next year i guess,
do you have to run two valves in the wheel? did you find any advantage over a beadlock wheel?? thanks Graham
Anyone know if you need a special wheel to mount a tire/tube/liner on to as we want to try non beadlocks on our pro mod, will a regular american...
Its the way to go, big bore smaller stroke 521 ci will rev and stay rogether way past 10k, The most common bae configeration in most pits so parts...
1.93/1 Low gear /first gear 1.37/1 2nd gear 1/1 3rd gear/high gear
this is no different to using a 2.5" spacer behind the pully. iv always been told its a bad thing and increases bearing load on the snout ect...
funny thing is i have a decent pro mod motor in fact about as good as it gets, good blower, cfh billet with my cbd 3 hole hat (the same hat 90% of...
youd be right Wayne the hemis realy hurt the blocks when they go we had a rod go in a chevy and it survived
our cast case K11 makes 42 psi our cfh billet case K11 makes slightly more but its warmer, all at 20% id say if you dont need to save a few...
our clevites always come out perfect and always have, oiling and oil used have a lot to do with how your bearings come out we turn our motor to...
so Manzo,Taylor,Hernandez Stott Burgess/Billes and more than a few dozen more are monkeys? I think they use a hemi cause they know from experience...
if it aint broke dont fix it
1 pro is the adjustable pump clamp so you can get the correct end float in your drive shaft without machining, i own and have used both, nothing...
whats your rear end ratio? how much weight do you have on the fingers?, how many turns of base total do you have?, two disc or 3? blower type and...
you say 45 lbs thats at idle right, our presure starts at 150 and is down to 70 or sometimes lower as i stage if i was ott in the burnout but it...
so did i just to be sure i wasnt dreaming but 6.3 it is
ok cool im just surprised as your a lot closer to the clutch than we are and as i said a n20 car needs 6.3 a pro mod be it nn20 or blower is 6.3 i...
You sure you just need a 6.2? even in our N20 super mod we needed 6.3, and we has a lot less horses and we wasnt sitting astride our lenco /drive...
should be sone small hex headed screws in the front of the case near the input shaft or just holes, if the screws are there remove them and use a...
the blower will beat you to the pit/staging lane!!!! or the fool who steped in front of you is a good catcher and catches your blower befour it...
