Separate names with a comma.
Take a look at this thread and see if that helps any....
I run 8 mm and use .004 per tooth, if I don't have any better data, and then read plugs. Sometimes I round down another . 005 or so depending on...
I've heard guys say that you should never trust the spec, always put the springs in a vice and measure coil bind on each one. I'm not sure I...
In my Chevy, the look of the ground strap is very dependent on where it's at in the chamber. I don't index, so completely ignore the strap. This...
Gotta love ITA. I was cruising the classifieds right after reading this.... You might want to take a gander.
maybe they're both right. Exhaust valve may have been glowing by the time the timing came bac in, which could cause detonation. Also, where is...
Mine has a spacer behind the cover. If I remember correctly,some bolts are screwed to spacer while most go through to the case. I just took mine...
Here is the history of the 14-71 high helix retro as I understand it. I would love for others that were around then to comment or correct. 1....
One of the smartest guys in the business looked at the pics of mine and told me I'd better say a few nice words to it and move on, it has took its...
Thanks mike. Just fast brackets. 8500 and 33% with the old blower. I'll need more eventually, but not a lot. The LF was probably capable of...
Broke my 07 littlefield hhr. Trying to replace it with something as good or slightly better. Does a k8 superman or an ssi d rotor fit the bill?
No idea when the crack happened, baseline tuneup was only set about 4 runs ago. I was actually getting ready to load the car to go racing last...
I found a crack/hole in #6 runner about the size of a quarter slot. I epoxied it up for now. 1. Any chance the epoxy will hold at 35 psi? 2....
This was one of my suspicions of what happened when I switched to 70w. I had run 15w40, 20w50 and straight 60 without trouble. I made a few...
I'm running a similar combo. Probably more boost. Mains are .0035. I'm running 20w-50 with a bottle of Lucas. 8.25 qts total fill with 1qt...
I just use the high side;). I don't think you said what motor. My BBC likes to be 8k in the burnout and the chip is at 8400 or 8500 on the grid....
The shop used a Bhj fixture that attaches to the heads. Appears the orings are dead on side to side except for the gaps. I have always heard not...
BBC, copper cometics, orings in the heads. I marked the gaskets clearly when pulling it down. I laid the gaskets on the correct sidesof the...
it sounds like this would make the front pressure higher than the op wants. You could make up an interface bracket. Shorten the brake handle rod...
Here is a good read on a similar scenario. To sum it up, more front weight, less aggressive four link, low tire pressure, and good shocks....
