Separate names with a comma.
Sheridan is selling (or maybe already sold) his 12 degree out of your sister car. I think he was under 20 psi to run 3s with a baby blower. I...
All of it. But you should set gap at .015. You sure you have enough timing in it? ~30 degrees with the zero mark Verified?
I've ran a 7al2 to 30+ psi and 8k+ with no problems. Even ran the little coil for awhile, saw zero change when I swapped to the bigger coil....
Not going to make 2000 with a std helix. If you're going to crank the std way up (60+), I would keep compression down at 11 or lower. Otherwise...
I run 30-31. Might go down to 29.5 if the water grains are really low. I Usually squish a bearing or two every 15 passes or so. I also have...
If you don't already have the mag, stick with a distributor. Msd crank trigger distributor with crab cap will let you run any blower you want. A...
Ok figured it out with a little help. Spirolock type thing has to come out from behind the bearing. I assume there is a tool for this but can't...
I need to take apart the 7-inch snout off of my ssi. Single bearing, driveshaft is part of the pulley flange. Looks like maybe a spirolock type...
Wow. Not having any useful advice is fine, but no need to be a dick. It doesn't puke under pressure, it pukes at the hit from the g forces. I...
did you try Fowler?
Well, cut it open enough to see that it's just not a great design. I wouldn't have known it wouldn't work by looking at it, but certainly see why...
I bought a few year old tank off of a member here. I think it's 3 gallon. Two 1 1/4 inlets and 1 3/4 outlet at the the top rear of the tank...
Yep. Mine wobbles the tire so often, I don't even notice. Except when it doesn't and it feels super smooth. But that's not really shake in my...
Enderle bird 12.25x4 opening on a ssi f3 with 11.5x4.5. Shelf in the back when looking along the airflow. Max rotor rpm So far is 11,400. I...
Gotcha. I guess I just figured I might have to get the grooves welded up and recut at some point. The one set is almost as much filler rod as...
I don't get it?? My most recent setup I put the oring in the heads. I was planning on doing a spare set the same way. Wasnt aware there was a...
1. Kobelco/fowler k11 2. Ssi f2 or newer 3. Littlefield lbxx(or the obscure LF k11) 4. 5. Anything with a k8 PSI fits in near the top...
Care to describe a "real" blower cam, because I think the one he pulled out was a pretty good stick. I backed to backed a "real" Bullet blower...
Excellent info with a couple exceptions. There is an F5. I think f3 or later will easily run 6.0s. And I THink the ODs being quoted are...
^^ that's what I ended up with. Mine is a 14xx serial number, but the only differences in F3s is high or low OD. Mine is a high OD. Compared to...
