Separate names with a comma.
Mike, when I read someones post who has a problem and needs help , I try to look at what they supply for info and WHAT they don't supply or think...
The only time I have seen something like this was when the mag and mag drive had bent shafts ------------ it doesn't take much and the mag in this...
Mc Kinney makes a good kit , just call there and ask Theresa for a kit , she will send ya a detailed list -----
Congrats Brandon !!! Great group of runs !
Have you tried a straight edge to see if all the pulleys are in the correct plane ?
That's what a Dry sump setup does -- it pumps more air than oil ----
Isn't it Carbon Fiber Andy ?
I won't argue about the merits of wire--- but I will say you shouldn't have to be doing it ----
Your problem most likely isn't bearing related ------at 10% od on the blower you aren't making alot of HP either --- is this a forged or billet...
Try posting alot more info on your whole combination of car, engine, oil pump type , oil you intened to use , what type of blower , how much boost...
Jay, why not take your own advice and state the name and situation of who you are unhappy about ???
Depends on the OD of the sleeve , there are three different OD 's available -- you need to measure the block's also as the blocks can be bored...
Good news -- so is it safe to say Critical Mass post was correct and maybe you mixed up your poppet location when you got your system back from Rage ?
I have seen some build wedge plates to compensate --------
Mike , to clarify this for me, what point on the RPM graph are you picking up these numbers from ?
What was your EGT's on your dyno pulls ?
You should always have a person in the seat when the car is running ON jackstands----and they should KNOW what to do in case of a problem occuring...
So when you guys check your rod bearings in the pits , what do you do with a warm rod when you retorque them ?
Dave, that is assuming you are looking at the back of the pump ? Not the front .
I have to tell ya , O rings don't "settle in" , there is something else affecting this as you say the pump performed on the bench-----it should...
