Separate names with a comma.
We have a 4:56 rear gear 34.5 Hoosier tires with beadlocks a 1.98 first gear in the trans.
I wanted opinions on this, We have a rodeck 526 with a 14/71 HH Roots blower and a lenco trans in a TA/FC. What would be a good RPM to launch on a...
Does anyone know what the rules are for the hold down straps for a TA/FC fuel tank thickness, width, material etc. Thanks
The sensors I have I got from Randy at RPM it's his Datta logger I'm using. I have to cut the ends off of the sensor probe How much should the...
How far from the header flange at the cylinder head should the EGT sensors be located? Thanks
The best silicone I have ever used is from the Chevrolet Dealers it's gray in color and cost about 25.00 a tube but it's great stuff.I have never...
check out nitroradios.com go to products and under keywords put in air systems they have a funny car system for 750.00 hope that is what your...
I Have Changed My Combo And We Need To Buy New Pulleys And Belts Just Wanting To Know Which Is The Best Belt To Run 13.9 -14mm- 8mm Etc On A 14/71...
We Have Always Ran The C&A Ring Just Tried These To See How They Worked. We Are Going To Re Ring It With The C&a Rings I'll Let You Know What Happens
We have 2 seperate engines both idenaical same everything one is about 60 hp down from the other. We switched carbs, ign. plugs & wires rechecked...
Anybody had problems getting total seal gap-less rings to seat. Ran the engine on a dyno to break it in made 3 pulls and have about 15-18 percent...
this engine does not have any oil to the top end the block is not drilled for it we have to lube everything after each pass all the oil stays in...
I have a canton oil pan with all the trap doors and a windage tray. It has a plug to check oil capacity in the side ,at the bottom of the hole the...
Hey Kevin, Rapid Randy- Nitro Madness had a used sae manifold on here for sale a week or so ago. might want to see if he still has it. Scott and...
I want to clean a blower bag anybody have thoughts about this and what is the best way to clean it also what to use on it? thanks
Hey Kevin ,try Jd2 Chassis They Have A Nice Air Manifold. I'm Not Sure If That's What Your Looking for . I Have One It's A Nice Piece See Ya Jamie
I"m Running A Gauge That Has A Sending Unit That Is Screwed Into The Back Of The Head So Would That Be Different Than The Black Spot Thanks
I Have Put A Cylinder Head Temperture Gauge On The Car. It's A Solid Block With Solid Heads On Alky What Range Should The Head Temps Run? Thanks
Anybody? I Know It's Old Stuff But Someone Other Than Hays Must Still Make Them Thanks
Hays 11inch disc and floaters Who has 11inch disc and floaters other than hays just looking who has the best deal thanks to all.
