Separate names with a comma.
To get this thing rolling (I hope), I'm gonna post the first tip. Check everything! Trust nobody! I was assured that my engine, a 511 KB...
I am getting ready to go back together with the engine I recently purchased, and thought this might be an opportunity to create a really useful...
This dragster is my first parachute car. I have changed the layout of the handles to suit me better, and was test-firing the chutes today, when...
www.akerlychilds.com -Scouder
I called them today needing one upper and lower main bearing. I have a set of M bearings in the engine that still look brand new and want to run...
William, Which part do you have a question about. Bearing smear or measuring "across the top"? -Scouder PS. Thanks Will. Very much.
Will, I was reading an old post of yours a while back in which you mentioned "fingernail" testing bearings. I am assuming you meant if it has...
The mains in my KB10 are Clevite MB3248M. Are they discontinued or something? I've searched all over the place on the internet and can't find...
Kevin, I'm pretty sure mine are stock, as they are all stamped with the same numbers as the block. It's just one of those deals where I'm new...
Thanks Robert. He tried to tell me my caps were either ductile iron or steel, I told him only if its that fancy new non-magnetic steel that...
A guy today said KB never sent a hemi block out with aluminum mains, but my Stage 10 has em. Doesn't sound right, but I thought I'd ask the...
If I get over in your neighborhood you can bet I'll stop and meet you guys. Also, If you are still planning on testing in Vegas in Feb and need...
Thanks guys. I really appreciate the help. I think I'll set it at 26 for the initial setup just to be safe, but I'll bet it'll like a little...
What kind of RPM are you guys running on fuel heads? Still new to all of this, and am trying to get some context. I understand that the pistons...
Hey guys, I need opinions on where to set my timing to start tuning. Obviously I want to start a little low, and bring it in as we tune, but I...
I am expecting a call from Randy at RPM on Monday. I will post the result of our conversation. I will be asking about the head temp sensor, and...
I was searching the forum for info on the idle poppet, and came across a post by Mike Canter that discussed how minor changes to the leakdown...
Thanks guys. I'm gonna begin re-assembly after the holidays, then the questions will REALLY start! -Scouder
So am I wasting my time worrying about a 1.7 gram difference in total rod weight? I am going to send off a rod and piston assembly (with rings...
I just weighed my new Brooks rods in preparation for balancing. I show a high-to-low of 1.7 grams. I haven't weighed the pistons yet, but assume...
