Separate names with a comma.
125" altered, 23T body, 427 chevy, 8-71 blower, all iron motor, with a glide, and it weighed 2110. I am 6'4" and 240. I have not weighed it yet...
I ran a blown alcohol chevy that I had a problem with it blowing the head gasket out. We found the problem to be the the receiver groove for the...
I use an old grass blower with and built a plate to mount to the can. I can send some pics if you like. Brian
6 months ago I sent my chutes to him to get redone. It took a bunch of calls before I could get ahold of Tom, but when I did, he took care of me...
You have a p/m. Brian
The ISP ones are from BSR Products. Call Trevor at 800-432-2798. Brian
Call BSR Products at 800-432-2798 and ask for Trevor. They call it the ISP drag racing head support. They were around $200.00 if I remember...
Also I have his e-mail as Kwhitney1@cox.net Brian
I saved this info a while back in case I ever needed it. I hope that it is still good. I have approximately 100 AIRCRAFT STARTERS in 14...
I was finally able to talk to Tom on friday. Thanks, Brian
Does anybody have a phone number or e-mail for Chute Metals? I have been trying to call for a couple of weeks, but I only get a message that says...
I had a similar problem, that ended up where a fuel check valve was stuck open. A drill will turn the pump fast enough, but the cranking speed of...
Have you tried doing the burnout w/o the pump all the way on? Seems to me that as long as you kept an eye on the temps, that you could try only...
Instead of running a timer, you could run an electronic valve. I got some from Holbrooks, and you could run it off of a toggle switch, and then to...
Also if you get it at a Natl event you can get it at 85%. Which saves you money. If you dont buy it at a Natl Event, it has to be shipped to you,...
Well here is my two cents worth. Buying any used truck is the same regardless of the GVW. Make sure that the engine, trans, rearend, tires, etc...
JW- If you could get me some measurements, that would be great. Mainly the height of the faria pump from the block, but also any other relevant...
It is hitting the top frame rail. I had to mount the engine about 1 inch higher than normal, because of how the rearend is mounted. I will lower...
I am putting a Keith Black hemi into a f/c frame, and the KB oil pump is hitting the frame. Does anyone make a smaller wet sump oil pump? I am...
