Separate names with a comma.
psi if you have a c rotor and can run it the class that you run why would you change it.
My understanding is if it is a light color mag case 206b they were modified into the retro 206d by changing the case and using the same rotors,...
I run the sheilded cable, lehaye trigger, I go thru rod bearing every three runs and the bearing was crushed 020, crank was not blackened and oil...
I have plenty of runs logged and the egt is the same or very little difference in that cylinder, the fuel system is spotless and have a filter in...
Lead came off and killed motor at wide open throttle, I hit the the kill switch at the stripe but the butterflys are closed.
Found a bent conrod in my motor, crank trigger wire came apart at 1200 ft, data is the same from all previous runs, is it possible that the motor...
I run the same deal, are the butterflies hard to open when the motor is running, if they aren't you need more air pressure because the vacuam is...
Hi Jason, tried to PM you it is blocked for some reason, any advise would be appreciated. Thanks, Matt
Is anybody going WOT with digital 2 step D series PSI, have been told it will kill the Motor?
What was the symtoms, I'm having an issue at the moment but had ruled out the 8973 because I disconected it and the motor was the same but maybe...
Have noticed a lot of funny cars with the wheelie bar set real low, about 1'' of the deck, these are single bar set ups, have a fair bit of flex...
I've never had a problem with the lenco drive transbrake holding, have run with PSI and superman and the superman was making 34lbs at 3500, holds...
I'm running 12.1 in my 451 fat 5 d psi combo at 68% over with no problems timing and overdrive will govern how much comp you can run.
Hi guys has anyone had any experience with the T&D rockers I know you can't use them in NHRA, I've heard that you have to clearance the push rod...
Car weight, rear end ratio, tyre hight and width, engine compression and ignition timing?
The easy way to get started is make sure the small slot cut into the spline of the spool is at the top basically straight up this will give you...
I've had a similar problem and it was the cam shaft phazed incorrectly, check cam install on 1 and 8 and make sure it reads the same or very...
I had the same problem with my car, shook and went right, retarded timing in first gear from 28 to 22, car went straight and 1.07 60ft, I leave at...
I've tried a few different fluids, fully syn motor cycle trans fluid 30 and 40 didn't help slippage, penrite 30 trans fluid, standard dextron 3...
Have a new trans speciality converter, will be running tomorrow, do you shut the motor down the same as with a converter with a diode, eg- pull...
