Separate names with a comma.
Hi guys, we run a MSD-10+ (with a standard cap MSD dizzy and crank trigger) as it puts out more grunt than anything other than the promag44. I...
Hi, this was with water heads - they were AFR 357's. Cheers
sorry, forgot to mention, we had a leak under that hat and could not get the idling right, it was too high but not hunting. The bolts at the front...
Hi all, we had the same problem and set the butterflies to 10-12 thou (smallest to largest) and played with our leak until we got it manageable....
Water or no water Hi there, we ran a similar setup dry (Blown Alky BB Chev)and managed to soften (and effectively destroy) one of our heads. I...
Hi guys, my understanding is that you should use solid core non helically wound wires for a mag. This will have implications if running data...
OK, great advise and thanks again for taking the time to help out. Cheers
Hi Mike, no I dont know the IC but I have worked it our before. I think I will try dropping the front of the top bars and see how I go as it cant...
Hi guys, no we dont have any retard devices, we are running MT slicks 32x16x15 with stiff side walls) set at between 5 1/2-6lb, the shocks are...
Hi all, we are running a heavy doorslammer type car (3,300lb) with a 3 stage auto and 1600BHP BB Chevy. We need to get more weight transfer to the...
you can also short the white whire to ground as thats a points input. Cheers
Wet sump for BB Chev Hi all, we have been running blown BB Chevys for years with a wet sump and no issues. Its only around 1600BHP but I rev it...
Hi Don, 28-30 degrees is where we started with our BB Chev, its plenty safe but is enough to get the thing running OK. Cheers
Hi, we ran a filled 2 bolt with Moroso splayed caps for many years around the 1200-1500 HP mark until a tired rod let go and destroyed everything...
Msd10+ Hi all, we have run a MSD10+ for 3 years and not had to replace the cap or leads in that time. The other thing to note is the voltage...
BB Chev oiling Hi all, we have always had the same issue but it dosent cause any damage as its not under power. We run a billet Moroso pump and...
Protecting electronic stuff Hi all, you can also put a zener diode across the 12v input to the device, I would suggest a 1watt 30volt zener as...
Blower OD Hi, we were running approx 7800 engine rpm at 45% over, went up to 52% and slowed down.
just stripped my alky blown 509 Chev after a seasons racing and putting it back together again with the same King bearings, they are like new both...
6-71 od Hi there, we found that around 40-45% OD on a teflon 6-71 was about the limit. Any more OD gave no improvement in ET or mph. This was on...
