Separate names with a comma.
MSD Parts 8147 44 points box w/ rev limiter (red) - SOLD 8145 44 points box (black) - SOLD 8168 pro mag timing retard box - $250 8676 Retard...
I've got about 10 runs on it. No problems to speak of. Just checked the bearings and they look new. I don't think you'll find anyone better to...
I went from a BAE to MBR over the winter and the only thing I changed was my front motor plate. The rear motor plate, can and clutch all bolted...
Look at Magnafuel part MRF-MP-3024
Bump to top
BAE Fathead valve cover gaskets - 3 Pairs White SCE #163075 - SOLD Old style black square MSD 44 coil, tested good - $75 14mm GT center...
Are you using a crank trigger or the mag pickup?
Do you have new plugs in it? Try swapping in new ones or changing your cold cylinder plugs to other cylinders and see if the problem follows.
I have my 1994 Freightliner registered as an RV with no stove or water in it. I have insurance through State Farm on that as well as my trailer....
I just ran a #6 line after the filter to the rear of the block. The #4 is for the gauge. Seems to help, didn't hurt anything. [IMG]
It's been a while, but I thought I would update. It began running progressively worse. I checked the msd crank trigger again and it was 154 ohms...
Mike that was with a changeover switch installed. I started with it on the mag pickup and it started, when the switch was flipped to the crank...
Well it may not be a cranking issue after all. After I got my change over switch I tested the timing on both the mag and crank trigger to be sure...
I don't know, never checked that. I can see next time I run. I got a changeover switch on the way and we'll see how that does.
What do you think it could be then?
It is a cranking speed issue. After I ran it wouldn't start again. I switched over to the mag and it started right up.
I got the coil used with the motor, I have an old black one for a spare. Coil wire is new this year (~15 runs). The rest of the plug wires are on...
It is a blower mount starter on 36v. Crank trigger air gap is .050. Plug gap is .015 on 6061-10. I haven't tried just off the mag yet, that was...
I've tried to start it a couple times after a run now with no luck. I hooked up a new points box the first time and it didn't help. Then I changed...
I have a blown BAE in a pulling truck. I have ran into this issue twice now. The first time I ran not very far and they pulled my kill switch...
