Separate names with a comma.
I am looking for the seal number for the rear seal on a CS1. It looks like it has 3897 stamped on the old one. Hopefully, I can get the correct...
Thanks for the info. Bickel had them. On the way.
Thanks I did call and she asked what year my wheels were bought. I told her 2001 and she recommended the new centers. However, she did not...
After seeing Chris Russo's Weld Alumastar center break, I checked my centers. I understand that they make a "severe duty" center now. Therefore,...
I was looking at the Lenco clutch disk for a CS1 and was wondering if this was a disk out of some type of OEM automatic that Lenco just uses....
I have an old style JBR 4 Hole low profile.
Does anyone have any experience with the Enderle Big and Ugly hat on the dyno vs a cardon fiber hat? I have not seen anything on how good the...
I ended up with a Bull Racing 10in 3 disk 6 small stand clutch. Bull Racing has since went out of business. I was told that it was design around...
Does anyone know what psi it takes to pop a SFI approved burst plate?
Yea, I can't seem to get away from it. It is sort of like a blower. Once you go blown you never want to go back. I think its the smell... We...
has anyone tried the MSD 7555 Cam Sync with a 8973 to put some retard in a single cyclinder?
RCD OffSet Mag drive and a Crank Trigger.
What do you mean go up .005? Set back is not a solution unless I get out the saw and start cutting out the windshield ;-).
All good questions and comments. However, no oil on the plugs. And when I say some cad left, I mean just a little is left. I could lean them...
the pipes are not that wet at launch. The egts leaving the line show all the cyclinders firing, non dead.
no, Kobelco 14-71 Hi Helix Superman at 34% overdrive. It is making 40lbs of boost. Blower is not set back.
We run the M soft rod bearings. We made two passes on new bearings. Tune up was 26 degrees on a BAE Fat Head. Good runs, plugs look fine all...
Got it, thanks. I have installed the capacitor. Lets go testing! Doug
Thanks, I did find on the "tree" part of the program there is a MagComp setting. It says when set to AUTO there is a 4 degree delay between input...
I just hooked our 8973 up this weekend. Started the car up and the timing droped 4 degress to 22 degress. Then I took the 8973 back out of the...
