Separate names with a comma.
Thanks for the advice but I guess my question is has anyone tried the Flatout brand gasket with embedded silicone? BAE Forged block (do they...
I can't seem to put enough silicone on the deck surface of my BAE forged block to stop it from leaking. Has anyone tried the Flatout brand gasket...
When the car didn't launch I let off the pedal right away. The engine went up a bunch but I don't think it hit my 8600 chip. If it did, it...
I broke a turbo input shaft this year leaving on the trans brake. It broke right at the hit. I bought the trans second hand so I don't know what...
In my opinion tape is far less reliable and more of a liability then the little button. I have been using it for 4 years and no problems. FYI,...
I bought my aluminum tubing from Wag-Aero. Also check out this fuel shutoff cable from Aircraft Spruce. In my opinion it is better than duct...
I used a cheap (Lisle brand) puller to take it off but you have to remove 3 studs. I bought a regular balancer installer then bought a long bolt...
I purchased a Racedata system and have been very happy with it. I paid around $2000 dollars and it came with the digital dash.:)
I have 2 .100 tall AJ manifolds. 1 has front burst panel and no repairs. 1 has rear burst panel and a little repair with an insert. If you are...
What do most people see for EGT temp at idle. Setup is a Hemi, 6-71 blower, hats and ports. Thanks for the info.
I made approximately 1000hp on a stock 440 block that was filled to the top with hard block and had billet main caps. It had a 6-71 retro that...
I want to see what everybody is running out there that has a similar combination to what I have. Combo is BAE Block w/ fuel crank and bore....
How much growth are people seeing on similar combos. BAE Billet block, Veney billet heads, blown alky. I used to subtract .006 on my old...
I am looking for some opinions on cylinder head torque setting. My setup is a BAE Billet block, 9/16 head studs top and bottom, 1/2 inners, Veney...
I am wondering if anybody does anything special to plug the down nozzle holes in fuel heads. Silicone or teflon paste or nothing? Aluminum or...
I didn't want to hijack the other thread with the title Oil Pressure but someone said that you don't want to use steel braided line to go from...
I am going to be purchasing a 20 firesuit in the next couple of weeks and it looks like Simpson has got a pretty good deal going. My problem is...
I just sent all my rockers to Stage V to be checked and rebuilt if needed. I think they charged $15 dollars for each roller tip they replaced....
I don't want to sound stupid but please explain how a Powerglide transmission would lock up the back tires after killing the engine?
Good question. I just bought one of those tools for my inner head studs but I have not received it yet. I was not aware of correction factors....
