Separate names with a comma.
Just wondered if anyone still sells or stocks saddles for Stage V KB blocks, also replacement main caps (centre main) with the two bolts per side...
This was how I was taught how to shut the motor down. Seems to work fine with my motor, but it's not as highly strung as some of the TAD / TAFC...
From the sounds of it I best stay with the big names, purely for peace of mind. We currently run a Bryant crank but it's very tired now and quite...
Hi guys. I know I'll get a fair selection of opinions and ideas about who's used what, but after a general consensus of good crankshaft...
Hey guys and girls. This one is for all those running MSD 44's, how have you grounded your heads? Where abouts on the heads are the grounds,...
A lot of replies. Here we go: Martyn / Mike: We ran the supermags at 34 degrees and currently run the ProMag at 28. Darren: We are running a...
Hi Mike; The plug leads were fresh 12 runs ago (fresh over the winter). I'll make sure to get a new wire set for next year. We have a spare rotor...
Hi guys. Still chasing MSD 44 ignition problems, though beginning to think we have a duff points box and coil. A fellow UK racer has kindly...
Hi guys. For this coming meeting i've very kindly been given a Waterman pump as a loaner to check our fuelling issues. This pump truly is a work...
Hi guys, thanks again for all your replies. I'll answer more of what you've asked. Mike: When we ran our old motor (JP1 432ci with AJ heads) we...
Thanks for the replies. Got some questions to those who replied. Ron C: Yea my dad is setting up these heads too, I haven't changed who builds...
Moparious: We are measuring it from the pocket to the bottom, so i'm guessing our method is correct. The flat shim method actually fits in that...
Hi guys. This one is for all the 'cylinder head' guys out there. We are having huge problems with keeping the top end of our motor together;...
Hi Vic: I will get in touch with a few of these and see what I can find suitable for us. Thanks!
Where can we get Spuds calculator and / or the jet sizing software? Sounds like good reading for my own car since we are currently chasing fuel...
Will probably get a few different ideas and opinions on this, so i'd like to hear the broad spectrum of ideas on the topic. We run a Enderle...
Hi guys. We were able to get a replacement set from a TAD racer over here, but I will obviously need to get another set as replacement, so any...
Hi Mike; Yea I'm beginning to come to that conclusion too. It was lucky we checked it actually, after a successful weekend racing (we took the...
Thanks Eli, thats all I needed to know. Gotta start routing around for a set of fingers and a thrust bearing (Or is it more formally known as a...
Hi guys. Found a thrust bearing had seized on my last run last weekend and it's worn the clutch fingers down to a stub... yea I know, a few...
