Separate names with a comma.
I have a 3 plate x 11" Crowerglide clutch on the back of my Nitro 392 Hemi. Im thinking about modifying it to make it into a 2 disc clutch....
my levers are .125's This is a fresh clutch set up and I havent run these levers before. I used to use .156 levers and around 100g total weight,...
How much weight should I have on my clutch? 3 plate 11" Crowerglide, small stand, 6 lever. my combo... Front engine nostalgia fuel dragster...
When adjusting a glide clutch between rounds, is it better to set the air gap by adjusting all the stands to exactly the same height, or is it...
What is the best surface roughness for a new set of freshly ground floaters? how coarse or smooth should I grind the plates? is it better to have...
Thanks for the advise. Where is the best place to install the gauge? in the port distribution block? the hat distribution block? or between pump...
Hi Dale, Blower is 8/71 at 20% over. Estimate boost at 20lbs. Hemi is 6.5 compression. I dont know the fuel pressure yet. Its a new combination...
Im setting up a 392 Donovan Hemi, to run 90% Nitro. Port nozzles are #85 to #92. I currently have #3 teflon & steel braid hoses with 90 degree...
I forgot to mention, it is a floater rear. The hubs are large billet 6061 alloy with MW studs 5 x 5" and spindles are 2.5" diameter 4340 in a...
Im seeking opinions on whether or not this diff combo is suitable for my application. Donovan 392 nostalgia fuel motor in a 180" FED. Only race 3...
a very good friend of mine who runs a top alcky dragster in New Zealand had the same problem. a new set of GRP's let go on just a couple of runs....
Looking at buying some new wheels for a N/TF front engine dragster. I want to use the M&H or Hoosier 16 x 12" NTF slicks....they spec 10" wheel...
Im looking for an alloy 9" diff center to replace a nodular iron unit. would appreciate any advise or recomendations on which units are best? or...
Thanks guys. I had 42" out with an alky motor and lenco. Now going nitro and direct drive so I had 36" in mind. Thanks for confirming I'm on the...
Can anyone recommend a good engine out distance? From Axle centerline to rear motor plate for a Front Engine Dragster? Chassis is 180". Nitro...
Hi Dave at ProBell, Im on the other side of the world, so I sent you an email instead calling.. Appreciate if you can contact me by email about...
Does anyone have a drawing, or dimensions for the bell housing bolt and engine dowel locations on Donovan 417 Hemi or a 392 Hemi? Need to make a...
Does anyone have an email address or contact details for Gary Burgin Enterprises? need to talk with them about Donovan 417 info. Cheers Dave
Hey Own Block....is that you Grant? hows that motor going? keeping the blower strapped down this year:) cheers, Dave A.
always looking out for parts for three engines. I have an iron 392 cackle motor and a Donovan NTF motor. a friend in CA also has an iron 392...
