Separate names with a comma.
How much plug gap are you running? Have fixed a lot of rod kicking Nitro Coupes by lowering gap to .011-.012. Wide gap under compression makes...
Lenco drive cooling Tap into the pressure side. We have been doing this for a while now and works great. Make sure to filter the oil, you are...
Powerglide Servo cover has pressure in low and high gear. Need min of 220# at idle. Most trans-brakes are designed to run boosted pressure all...
cutout Had the exact thing happen on 526 kb olds with Mallory III. The cause was the cutoff switch on the dyno couldn't handle the mag's primary...
Plug gap We run a max of .012 on any blown application. When testing there was a HUGE difference between .012 and .018. When under high...
Magnecor We have been using Magnecor wires with good results. Thought the MSD wires failed too often. www.magnecor.com
Flowedge Contact Britt at Flowedge Fuel Systems. He has setup all kinds of systems. Has tuneups from NHRA alcohol funny cars when they ran...
vernier cable http://www.goodboatgear.com/detail/6950/%20Vernier%20Cables http://eriksmilitarysurplus.com/thcoca10ftwi.html Scott, We have...
Powerglide Scouder, Some valve bodies use the 1-2 shift valve for a switch valve instead of a check ball. Make sure it is assembled properly...
Flowedge Give Britt Micetich a call. New business. New digital flowbench. FLOWEDGE FUEL SYSTEMS. Lots of injected and blown experience....
fitting Just wanted to make sure I understand correctly. Is this what you are talking about....
Pick off connector If your talking about the pickoff on the flowmeter, I've been using a mil spec made by Amphenol. You can customize the...
Probably have to give Littlefield a call. Too many unknowns. Is Force using the same setup as his fuel blowers? If temp is not figured in to the...
I read it as : 3 blower being compared. 1st column is rotor rpm/ psi @ 3450 cfm, 2nd column is rotor rpm/ psi @ 3525 cfm, 3rd column rotor...
more fuel If you have a good tune up now then add the percent of change in air. From 1.20 to 1.35 is a 12.5% change. Take your fuel gpm now...
Check balls Have worked on many powerglides. Check balls depend on who made it. I've seen no balls, one or two balls but I don't remember any...
If your valve has 1/8 npt then is should flow mid to high .070's . We have modified them to flow up around .100.
% of change I agree with JRB about adding same fuel as % of change, but I don't agree with the math. 1.3-1.25 =.05 .05/1.25=.04 that is...
Jet tower Here's some jet towers. http://www.hemipartsking.com/store/?p=productsMore&iProduct=72&sName=aft-jet-towers-with-large-control-cylinder
Cooler circuit feeds cooler oil to lube bushings and planetary gears. I wouldn't return the oil straight to the pan unless you want to have major...
