Separate names with a comma.
I just tested the lines with air pressure for obvious leaks. Admittedly not the most detailed testing. Just what I could do in the shop quick...
Good point. I pressure tested every single line. But that was in a disassembled state, which wouldn't have shown a stress crack in a fitting....
Another update. Fuel pump failed at track testing again Sunday. It now looks like the o-ring between the pump housing and the face plate may be...
Fuel pump tested and checked out ok. Looks like I'm re-plumbing a bigger line from the tank to the pump and validating my vent size. Thanks for...
Did not try to restart engine. Wanted to inspect for cause before trying to restart. Have subsequently turned it over with no issues. Plugs...
In response to the prior post, I am reading fuel pressure after the pump but before the K-valve. I need to recheck the shaft engagement, as...
Mike - I have an over-center bracket with spring to hold the shut-off open. And I physically shut it off as soon as I heard the issue. I thought...
Scott, It's a 2012 American Dragster with a plastic tank behind the driver's seat. I plumbed all of the returns back to a manifold on the...
Dave, I think you've got my contact info. Give me a call if you can this morning. Fuel level was and is still about 80%. I think it's a -12...
I run an Enderle 990 fuel pump. Yesterday in testing right after I shifted into 2nd gear I heard a whooooosh and thought sure I had thrown a...
Just to close off the issue: We installed an 8973 ProMag Ignition and added an RCD crank hub and degree wheel along with a Leahy pickup....
Promag 12LT. Yes - I know that's not very ideal. On the upgrade list. ;)
I've looked on their site but can't find anything that looks like a degree wheel w/magnets, etc. Am I missing something?
Great responses everyone. I think I'll just go to RCD for a crank trigger setup. Thank you!!
I currently am running a Mag off a front gear drive (angled up - not direct) and no crank trigger. Timing looks horrible. I assume cam end-play...
I went to a blower this year and now have zoomies instead of a conventional header with collector, so my O2 sensors became worthless to me....
I've been running Lucas 50 plus oil so far this season, and oil pressure is still fine. But as hot as it's getting is there a reason to switch to...
This might even be my first post, because this is my first season with a blown alcohol motor. I've been searching, reading, and learning for...
Cancelled. Again. Trying to make it up Thursday and Friday June 6-7 at the Chicago Divisional.
