Separate names with a comma.
would anybody know if these block have oiling problems, if so what would a person need to do to correct it, running low hp blown deal 1200 hp in...
hi would anybody know what colour of stands I need for my .100 tall fuel heads. will be running them with my dick landry roller rockers. dont have...
hi do they make blower engine bearings in .030 to .040 for crank and rod, use will be 15 to 20 lbs boost 7000 rpm big block chevy. have a crower...
hi what main and rod clearances do you run?
do they make a bearing in sizes .030 and .040 rod and mains for light blown use 1000 to 1200 hp thx :cool:
thx scott :cool:
hi have a water block email me back at mudd_bugger@hotmail.com thx rob
what is the weight of a bae billet block with sleeves thx
hi depends how much your paying for the engine, if its cheap pick it up. but if ur going to do mods buy a hemi.
hi robert, what about a raised cam gear drive for a bae billet block? are they the same crank and cam gear, and you just need a raised cam cover? thx
rods hi if the rods are not new change the rod bolts for sure, L-19, bud ran stock eagle rotating assembly for 8 years, and the last 2 years he...
any picticular places where you might think to put the sonic tester to, that is most likely a place where they start rusting in 30 year plus frames?
some body also said for the rear main, .005 to .005.5 :cool:
here is a link to the chevy build. http://nitroimage.proboards.com/index.cgi?action=display&board=GRD&thread=2259&page=1#12022
got them from alex, off ebay excellent prices. check him out engine-parts@sbcglobal.net
hey can u email me at mudd_bugger@hotmail.com would like to talk to you about steel rods in my combo thx rob
low deck ehh. maybe a 400 mopar low deck, possibly a hemi low deck.
don friends of mine both got bad batches of rods, which blew the motor. also 1 friend blew his motor, only to find out the rod bolts werent...
friend had an older set of bae fuel heads he used a 4.5 stroke and 1.428 piston comp height, with 7.08 rod length and a .043 thou gasket on a...
do u have to mic the bearing for its thickness, so it doesnt spin and spit out the rods. or mic the big end of the rods to make sure the bearing...
