Separate names with a comma.
Vacuum/pressure ? in hat We have just recently hooked up a RPM data logger and included a MAP sensor in the hat. This is a 8/71 standard helix/...
Top gear retard My understanding of TGR goes like this -in the lower gears the engine is able to build revs fast due to reduced load and...
100+ psi We had the same problem with our dual guage tester and the compressor dropping below 100psi before it cut in. I now have a bottle of dry...
Hi Dan. You have had the car going well into the six`s so I appreciate that you have a very good understanding of what you are doing and I...
Im no mathmatician so I will trust that your figures are good. 120lb sounds like a minor penalty to reduce inlet temperature by 320! degrees, plus...
If I read it correctly, you are saying that by simply removing the intercooler and changing from petrol to alcohol, the boost reading in the...
Pump saver We run the pump saver back to the hat distribution block for a bit more cool/lube in the blower past the finish line. Cheers Jim
3/16 or 1/4 The above groove may be to suit 1/4" o-ring as 3/16 is only 0.1875" and would not be held in the groove. Jim
My 2 cents We run a BBC with a Supermag 3 with 3.8 amps running low 7`s / high 6`s. When I read about the grounding issue on this website about a...
We have a large electric pot that was originally used for boiling shellfish that we boil our oil in. Tip it all in, heat it up and the alcohol...
I`ve been doing it with the hat and port lines hooked up as well. I`ve just gone and checked BV leak with and without the hat and port lines...
Hi-speed fuel redirection system Eli, I will be interested to see if you can find any power/speed gains with your new setup. What do you think of...
Hi speed to hat Hi Eli, is what you are suggesting to alter the ratio of fuel under and over the blower as speed and boost rise ? An interesting...
Thanks for the reply Mike. With the pressure difference the hi-speed sees before and after the B/V, is that an indication there is significant...
Question for Mike Hi Mike, I have known people to say to run the hi-speed off the port nozzles before but have never heard a satisfactory...
We are running Oliver steel rods in our 560 BBC and have had no problems sofar (3 years) . Running a 8/71 at 50 over (20lb), changing gear at...
Unfortunately a stock crank won`t last very long at 12-1400 hp.
Fuel filter The one time I saw a filter cartridge upside down in a System One fuel filter there was not enough fuel flow for the engine to run...
2 x chutes Thanks for the help guys. Talked to Shroud and have two chutes and launchers on the way. Cheers Jim:)
I am after some advise on changing to a dual parachute setup as we are approaching 200mph and expect to be there during the coming season. At the...
