Separate names with a comma.
I saw a thread awhile back asking the question if anybody rebuilds Crane Lifters. It turned into a buy cam effects lifters thread. Is anyone...
Call Jerry @ Brooks, great cutomer service and a heck of a good guy. Get it straight from the source. Address: 735 E Debra Ln Anaheim, CA,...
I'm not looking to get into a pissing match with Noel Manton. For a sponsor of a tech question section I sure don't know what the hell his...
Sure, lets just get the GM part number and ordering up a set? Why would anyone even sell a 3/8 pushrod then?
Scary t-wrecks, I've been agreeing with all your posts (hope we don't get in trouble)........ Your motor will like the long rod. As a second...
Ageed. When you get into 4.5 stroke on a chevy without a raised cam, things start getting pretty close - lots of check and recheck on cam to rod...
I think you'll be fine. I did 3/8 heavywall pushrods on 350# seat no problem. If you get into bigger (7/16) pushrods, the weight of the oil...
You may be right on that.
System 1 #1 option I eliminated problems switching to the system one about 10 years ago, I'll never go back to paper (Fram HP series) with my...
Polish the crank I think you're better off adjusting your journal diameter for the clearances you desire with standard bearings. Then it's not a...
Too tight My opinion..... those clearances would be fine for an iron block steel rod combo. Add .001 to your spec's on both main and rod and...
I run an Engle. Some guys run Comp cams. There's others, not a huge variation of grinds like there is for Chevy's.
I've always had good dealings with Brooks. I did my own cam clearance in my last set of rods under the direction of the people at Brooks. Seems...
I don't know of any in OK. Races close to you in Kansas are: Smokin' in the cove Arkansas (Malvern/lake catherine) usually the end of Sept. St...
Talked to him this morning, thank you. Just a generic message machine at the shop. Brooks has me covered on sevice.
Is Brooks still in business? Tried calling the shop in LA the past couple of weeks with no success - non business sounding message on the machine....
visor insert They work great - no dispute. Seems like they have a one year life span (or there abouts) before they "haze" and need replacement....
Thank you Paul. I got playing with what you said last night schematic wise on paper - it's all coming together mentally (got it). I really...
Thank you Paul. You have the idea I'm thinking of figured out. The switch you mention as you're describing, is it a MSD part or something else?...
Can anyone point me in the right direction on this one.....? Would like to activate and latch the air solinoid for my clutch from a RPM activated...
