Separate names with a comma.
Have the chance to buy a bae fuel block Question: Sleeve size now is 4.187 what is the largest I can bore these sleeves to? so I can buy...
Msd 8973 Thanks for your reply Will. Never run a capacitor now have one. I will get a crank trigger now as well, It has always been a guess at...
Timing controller 8973 Thanks for your replys Anyone else
Hi, I am going to hook up a 8973 timing controller in the next week or so. Questions: Do I need to use a 8830 capacitor ? Do I have use a...
Amsoil Yes I am using it in a lencodrive compresser oil Sae 20 I think . it seem to take more heat.
Brandon thanks for the reply sounds like you run one I will send you a email as soon as I get time. It will come from quick cut concrete Thanks Dave
Lenco Drive what rpm can you rev to when in stage, with out pulling through & frying the clutches. convertor locks up & pull motor down at...
Fuel Press Mike, Mine is the same come & have a look or I could email a picture if you want Dave
Timing Dave, Whats the diff between the heads & timing thanks
Crank Bryant 4.250 Was getting finish when I rang Had it in 5 Day in Australia At the right price as well Best service.
Advance Dave So you ran this FED on the weekend tell us How much timeing did you run ? What did you run ? Was it 6.3 ? Regards Dave Quick...
Fluid Hi what to run in a Lenco drive I have fryed my box twice now intrested in the Lat Oil what type & weigth & part number & who too talk to...
Cam Good to here from you Noel. I need some push rods etc Intake are bae aluminum Exhaust are steel Dave
Liners Hi these are good I have a set on my funnycar slicks 5 liner 45 is a good starting point Mine don't move on the rims like the old ones...
Cam Brandon Thanks for your reply, Read the lift straight from the cam card. how do I or do I find the lobe diameter & then my rocker ratio ?...
Hi what cam do I need ? I have been Breaking rocker gear left right & centre I think it is coil binding heads have just been serviced....
Thanks alot for the replys
Ok, Question just freshing my Hemi 4.375 bore Just brought new rings Akerly & Childs Xtreme What gap do I run ? Top? 2nd? Oil? Thanks
Bearings Thanks John
Dose anyone know the difference between MB-3248 M & MS- 1795 M Clevite Main Bearings ? I have used the MB before but are not shaw on the MS-...
