Separate names with a comma.
When I was running a turbo car we would drain the fuel system and dump some gasoline in, load the gas file in and start it up and let it idle. We...
Holy injector Batman! Who makes that thing and how is the idle with all that throttle blade area?
Do you happen to have a GPM number for the c rotor at 3500hp vs. the 88 mm turbo at 3500 hp? Ie does it take the same fuel make the same power in...
The Rockwell is only a piece of the puzzle and so much of the clutch tuneup is based upon the discs. This is why you will see guys using the same...
You can put a couple on nozzle checks to help get your idle where you want it and then set them to open just above idle. Don't get too carried...
Clutch rub plate How much clearance is needed between the back of the flywheel and the mid plate rub block? We are running an aluminum flywheel,...
If you are able to pull that adapter at an angle of 90* you don't need to refigure the torque setting.
Have you had your coil sent out and checked out lately or have you tried a different one?
I'm thinking that the main benefit would be you can change the ride height without jacking on the spring like in a strut deal. Also opens up the...
Did you have the relief all the way in on your g-rotor pump? In the video Mr. Miller states something to the effect of wide open no relief. In the...
Are turbos allowed or is this going to be strictly a roots deal? A lot of those top dragster guys run 526 cu in stuff, maybe have a reduced engine...
Have you taken the engine apart yet? Are all of the rollers accounted for? Were they accounted for last time or was there possibly a rouge on...
What type and style of bearings are you running on the mains and the rods? For example; clevite M What's the side clearance like? Are you...
I doubt that the valve angles posted above are close to the 481x. I understand it being considered a "Chevy" and all but I don't think those...
They make morse cables in different thicknesses, you just purchase a thicker one and machine a groove into it. You can run a heel toe type...
One would cut a groove into the throttle cable and use a hair pin in the groove. When you bring the engine up, the driver feels resistance and...
Is anyone paying attention to RPM drop after the shifts or does this take a back seat as long as the wheel speed is good within the 1st second? I...
WTB Bonifante 10" clutch disc with 1 3/8 spline. Looking for .320 or thicker. Also looking for a triple disc clutch alignment tool 1 3/8-10...
Any idea what the flash point of the redline ATF is? I seen that they had a higher temp version on their website but neither lists a flash point....
Is there a reason you are looking at going belt drive? You don't have to worry about belt breakage with a gear drive. One belt break and your...
