Separate names with a comma.
We use an inner head stud tool to torque them, but if you want a ratchet you maybe want to consider a ratchet spanner instead of a wrench. I don't...
welding Good practice: ground clamp close to where you weld.
Hi Robert, We have a fault in our MSD 8147. (No spark). Easily solved (repair by replacement), but question now of course is what to do next....
Caustic soda will do the trick. It's used in oven cleaners, but also in the pellets / liquids used to clean the pipes of your toilet / sink. A...
No experience there, but aluminium will expand twice as much as steel when heat is applied, so if you warm the head (careful) it should at least...
I know for a fact that in some of the MSD documentation they mention Deutsch connectors. I think for the 8973 timing controller. These connectors...
Rev limit One more thing to note: for how long will you run it at high rpm? Drag racing engines may go up to 10000 rpm before they switch over...
Maybe the picture on the FIE site will help. http://fuelinjectionent.com/webstore/product_info.php?cPath=21_35&products_id=93 At least it shows...
Forged v Cast No experience yet to be able to compare but heard two things: Keeping stuff in the block is nice if you're not allowed to spill...
Brooks rods Hi, This is what I've been told. Black washers up to 90 lbft in steps as below. Silver washer only to 75, same steps, only 50 WT...
Hemi v wedge We switched from a wedge to a hemi. I think you can probably get the same power from a wedge, but it's easier (you can buy it) with...
Ours are Arias, but non-stock items. They may very well be BAE standard, but I haven't asked them yet. Last time I asked they were around 90 usd /...
Don't know about common, but ours are 1.555 comp height also on a 4.375 bore with rods made to match.
You need to exchange two pieces. One in the bottom part which determines firing angle with the internal trigger. And one in the upper part phasing...
There may be two more things to check. I think the minimum advised starting speed is 200 rpm. We have an older unit that's fine at lower rpm, but...
Jason, It could be interference, but we do fine without shielding on our PM44. Make sure your tach is for inductive style pickups and...
Thanks Darren, I'm sure the phone number will come in handy in the future. In the meantime we opened it up and found an F stamped on the front...
I think we had a Cragar one like that on our BBC. Basically the plate you mentioned is kept in place by 2 valve springs and it will lift during...
I'm sure somebody brought this up before, but just couldn't find it. How can you tell which type of rotor is in a 14-71 HH SSI blower. As far as...
Thanks guys. We will be lapping as usual.
