Separate names with a comma.
Thanks for the big help on this one Rob. I'll probably have to read it a couple of times and draw up some figures to fully get all the details,...
Hi, Just looking for info on cams for supercharged engines but can't find anything decent. I can of course have a cam made to order or buy one...
Maybe a bit too simple, but once you have pushed air into the burst panel pocket there is local high pressure there and this may just act as a...
You could phase the mag at 27 deg and set the crank trigger at 32 deg. Start using the internal trigger and switch over to crank trigger when...
We just use the foam with the stainless 'manifold end retainers' as you probably know or will find on the BAE website. Only issues we had were...
Use the extension at a 90 degree angle to your torque wrench. No correction required then.
We're ignorant / lazy or both and we still get away with just using the torque wrench, but I would have to agree that stretch is the only true...
http://www.blowerdriveservice.com/torque-specs.html
Slightly different setup, but thought I would add it anyway. 4.375 bore, but only minor differences. Piston 764 Buttons 20 Pin (1.156) 264...
We did some testing once. Testing the pump is pretty straight forward if you have access to the parts. Start with a variable speed drive motor...
Assuming you check lift on the valve: Are you using the correct valve lash to check opening / closing times? If opening is late and closing is...
We had some issues with detonation once. EGT went down during detonation on our combo and it didn't respond to fuelling untill we put a lot more...
Caustic soda I know caustic soda will do the trick, but a wing might be a bit expensive to experiment on. I've used caustic soda (drain cleaner)...
Play around with the Excel sheet on this page and it will give you some idea: http://www.dtec.net.au/Downloads.htm On a fractional HP moped it...
We once had a similar issue. The answer was a New Century and now we run a BAE hemi...
If bolts show permanent deformation (bent) then they have been stressed beyond the yield point. If this happens with two bolts which are known to...
Rod bolts can bend if the other (opposite) bolt is loose. It would expect signs of movement on the serrated parts of rod and cap though. Normally...
Could be as simple as to avoid galling between mating stainless steel fittings. Not really an issue when combining stainless with anodised...
We once destroyed a cam and put a new one in with bigger lobe separation. Didn't really notice major changes in power, but we burnt 3 pistons...
Have you tried the fit of the pin in the individual parts? If you feel resistance that could be just because of the bore of the gear and the bore...
