Separate names with a comma.
former 20 owner I ran 3 - 20's for several years. The boxes were a continouis issue. I was told it was because the system was a hopped up 12....
1705 interested in 1705 belt, your PM box is full!
at this point i a not sure of anything. it is still in the tractor, going to put a new cam in and see what happens.
Cam shaft was tight when i took it out. Another goes in easily, so i am figuring the cam is crooked. What procedure do you use to straighten the...
cam bolts I have used a half inch wrench on my torque wrench before. the last time i had a cam break loose was in 1998, multi ply 18 yrs, times...
torque is there such a thing as a torque box end wrench, so you can get behind the mag drive gear on the front of the cam?
What are the recommendations for chevy cam shaft bolts or studs when using a pioneer/archer front mag drive? If using ARP bolts, do you use the...
replacement lines. would you mined letting us in on the fittings you use? my lines are well over 10 yrs old. thank you Richard
lines Will what are your lines?
Had a port nozzle plug and burnt a piston, first time in 25 yrs. and burnt a piston. It was the first run after the winter, the material could...
Looking for a 12 volt pump to transfer Methanol from barrels to jugs, with out breaking the racing budget. Does anyone have any recommendations.
thicker bearing I may be wrong, but I do not believe the thicker bearing is in the bearing material, it is in the backing which would not help...
crank grinding Am i reading this correctly, you have a crank with good journals that is Std, and you are asking if you should turn it 10/10 when...
backwards pully Yes, ran it that way for several years, it did eventually take out the bearings. I am thinking I even had a spacer with it!
Did you put new rings in?
If the clearances are not enough for the 70 wgt, just add some 50. I am in NY, no oil heater, have run 50-60 & 70 without a problem with the...
regarding the cold cylinders, is there a chance the plug wires are hooked up to the wrong cylinders, either at the plug or mag cap?
Bearing Clearance sorry if i missed this, what clearance are you running on the bearings. If you are changing oil weight, were you not happy with...
I have a friend in Europe, tractor pulling organization is working on engine limits, he is looking for dyno sheets that they could use to compare...
turn around not a lot more if need be. motors were not hurt. broke the weld on the cross box mount to frame stripped the nuts on the back of...
