Separate names with a comma.
I do get the larger parts from Lenco and agree that their service and advise is great (except when it comes to the older fibres and parts) they...
What sort do you have. Just went through this the hard way. Do you have the old pointy red ones. Lenco will not sell these to you so try ALTO...
I've got coated CPs in same combo
I never rely on the little indent spring on the side of the reverser. get a lever that locks.
when you said Rig welder did you mean Tig or Mig?
no. Most people just spot it and then remove the pump. Please disconnect the fuel from the area
This only works for a 4-3
why put the Nitro through the pump? Could you inject it into the runner like a wet N2O system?
mate got very sick working with at team as a mechanic due to Nitro/meth fuel. Read MSDS. As above try something else, gloves hat, hand...
I went to Hussey Performance web page. Nothing to see there other than the std order forms that any rod builder asks for. Page still has 2009...
When You said nothing when you tried to buzz the Mag? Your not trying to buzz a MSD as it won't work. Just asking
As a sparkie I like the 12V to the noid and 24v to the armature
I have a 540 4.5bore 4.25 stroke in a 9.8 with a 14/71 wedge heads wish I had a 10.2 would have made the rods/pistons easier, and manifold/port...
8mm GT belts and pulleys. I just buy them off goodvibrations no issues at all
Software Copy to <Tyson.Park@Ergon.com.au> please
Not sure about the USA but in Australia (and we share copyright protection laws) parts for automotive repairs are not subject to copyright if used...
N2O SBC removed t400 installed 4 speed Lenco with single plate clutch picked up 50lb not much in a 3550 car picked up a lot of ET and MPH...
Don, I have the Summer Bros drive. I mounted the block mount idler bracker behind the mag drive with just the 6mm (0.250inch) plate behind it....
Mike, Value your input, I have a 60* 14/71 with a pie opening.(not retro) When we purchased (good vibs) it we were told that it would make...
No idea really but if I was thinking about it I would. Start with a thick plate and mill in a riser to go into the large opening. cut the pie....
