Separate names with a comma.
I don't know about TA/FC but on my blown altered I ran the whitey valve off of the T on the fuel pump shutoff. As far as running the line back to...
It is best to set the block where you want it and measure with a piece of similar hose and mark where you want it cut, pull back off and measure...
I run lower 30's in some of my ports. Make sure you figure area and not the number on the jet. I knew a not so bright guy that did it and he...
I have been running Clevite 77 H bearings in my steel rod, blown big block chevy since I built it (low 4.20's in the eighth, altered) . I ordered...
I run Oreilly brand dexron 3. I change fluid once a year and run it in 6.70 blown altered. I tore trans down this year after 4 years of running...
Also, make sure that when you pull the cable it goes partway into the outer sheath. If there is any still sticking out of the sheath when it is...
.036 on top (Hellfire) and .032 for the second (cast). 4.50 bore. Talked to the tech guy at Arias. This is what they have arived at based on...
Did some calling around today and got my answer. Thanks for the replies. Adam
quick question. What are you guys gapping your rings at per inch of bore. Hellfire top ring and cast second ring Blown Alchol BBC. Arias wants...
Is this a dragster or a funny car chassis. I used to have the same problem on the 36" tires (funny chassis, BBC Glide 4.33 gear ratio) but I...
I had a Defender and absolutely hated it. I couldn't get my helmet down all the way and never made a lap with it on. At least they took it back....
Then when your done do some dry hops. JK Some people in the crowd like them but it makes me laugh. I mean seriously, why do people still do...
I like to roll all the way through the water and lightly wap the throttle and hold it at 7,000. I think rolling through the water with some light...
The literature I got with the block says it weighs 292 lbs.
I have a Merlin Pro block that I bought brand new. I can tell you it has billet splayed mains and dual bolt patterns on the oil pan rail. Mine...
Sent you an email with pic
Run port nozzles. If nothing else for the individual cyl tuneability. Like said in previous post, if you don't want it flip the check valve...
Took pistons and block into machine shop and he said the block is not the problem. Piston skirts are collapsed on at least 4 pistons. He also...
Yes, they are blower specific pistons. Slight detonation could be the problem. All the grooves in the cylinders are perpendicular of the wrist...
Thanks Scott, hopefully it's not bad. The pistons don't really look that bad but 3 cyls on right bank have grooves in various spots.
