Separate names with a comma.
email I just emailed something close to that to espn. when they get flooded with emails,maybe they will get the hint.
both both upper and lower will clip on the crank..had 34* of timing in the motor and have ran the motor at 33* with no prob. main bearing look...
just checked bearings on my blown sbc. #1,2,3,4 rod bearings are trashed. no crush on upper, the bearing dia. shrunk? 5,6,7,8 look good. bearing...
never said i could make it run without blowin the tires off it:confused::confused: thought you use a can of blower gel a race:eek: when gorr...
my blown sbc 400. has 120psi cold cranking and running 45lbs of boost.
we use 64 thou. flatout gaskets the RCC. on a blown small block 46lbs boost and run water threw block and heads.
on the step retard there is a sec. box you can put how much time you want it out then have the rpm box set at the shift point, then the hot wire...
when i worked on medlens car in 05. we was breaking side bolts in the mains. come to find out it was becouse we was washing them with solvnt and...
yes its a msd pro mag 20 with the 8106 points box. springs on the seat are 360lb. checked cam. its dead on with the cam card. it has done this...
blown sbc. BV leak 78% 5lb check 1800rpm 20amp mag. set at 33* checked TDC pointer., running VP M5 fuel. at ilde it pops and flames at idle....
When I worked for John Force they had us use pledge. easyer to scrap off and the TI tree you could just wipe it off with a rag
The car runs to 6700rpm and acts like it hits a rev chip..took chip out, took fuel out...shoots raw fuel out all the zoomies. 1st run it did it at...
2 or 3speed Thanks guys. the motor came out of a 280inch dragster 1950lb with 34.5 tire. they where running a 3speed lencodrive. and worked...
Have a 125inch altered. Blown small block 388 10-71 HH kobleco with inlet mods 33% over. -12 heads 9200 shift. 33.5-17 D1 tire. 3.89 4.11 4.30...
Eric was allways in the pits with a smile. I had the honor to work with Eric as a team mate in 05-06. Even on the hardest days he could bring joy...
lube When i worked on medlens FC they used WD40..Becouse the spray gets into the tight spots.
