Separate names with a comma.
Brain Fart, Yes !
depending on the angle of the drive shaft and what kind of rod ends are used a 0 degree pinion angle is not un common some times, alot of people...
I wont give anymore opinions, thats for sure.
for one material of the valve makes a difference also, whether it be titanium or stainless steel, but in your case for either the pressure you...
I apologize, whoa ! 3.875 ? Yeah that would be a little small.
That is not 425 cu.in. it is about 540, I would go for bore over stroke, valve unshrouding is not the issue, blower motors make alot of torque...
Yes thank You. My Little Sister and Brother in law are leaving back for Afganistan today, they were on a 15 day leave and will return in April,...
Tommy the Shoe Hand-- Tommy Hand Marine corps TAD Div. 4
This is the first time I've ever really heard anyone put out the pros and cons of the two shows, I've asked vendors which one they like and I get...
If you wanna contact Me. www.hensonracingengines.com
Agreed ^^^^^
I agree but thought I would try, according to the video it was definately smackin them on the ground and unloading the rear tires, keep the advice...
I built a 377" small block a few years back using a stock 400 chevy block and a stock 5140 chevy 3.48" stroke crank, it made about 650 hp on 110...
Thanks for the reply Jim, backing it down to go from a to b is definately a hard thing to do for Me but I will try, I had a friend of mine come...
Now I'm Jealous.
Contact JR at RBS superchargers, www.rbssuperchargers.com
Crankshaft flex will cause this. imo.
I use to run a vac. pump on an alcohol nitrous assisted motor and kept having lean issues and melting pistons, we put this setup on the dyno and...
X2 on JR at rbs superchargers
Looking for a good used timing controller for an MSD 20 Magneto
