Separate names with a comma.
Thank you for the information !
hi all! sorry for asking what might seem to most of you obvious,but i'd rather ask before spending my hard earned cash: do lencodrives and bruno...
Thanks Wayne and Mike for the infos!
is the amount of oil in it based on a "stock"bruno oil pan? the reason for asking is i bought my bruno drive with a custom fabricated oil pan that...
thanks a lot Mike!
Hi all,this is Cyril again... what are those using a bruno drive doing regarding cooling? Here in France,one door car racer has a radiator on his...
thank you all for the input and advice. this block has been repaired already(windowed on both sides,plus repairs on the center main cap.so it will...
hi at the bottom,sleeves were tight before the impregnation process,and they are even tighter now. and after finding some instructions about the...
Ok.i Impregnation is an industrial process that consist of setting a part(or multiple parts depending on their size)in a sealed tank,that is then...
It is not filled My machine shop is advising me to do it before the honing and decking processes. I want to make sure i fill it(1.5 inches) with...
this is a wet block(when a sleeve is removed,i see the one next to it). when my machine shop found out about my sleeves being out of round,he said...
Hi all! i am about to have a repaired KB stage 6 hemi block machined (bores opened from 4.310 to 4.375) since my last thread about sleeves moving...
Thanks a lot for answers and parts offerts! Currently scratching my head to make a screw blown KB hemi fit where there used to be a chevy based...
thanks a lot for the explanation and solution!
Hi all! first,let me apologize in advance if this is a dumb question: is it possible to use a wet sump oil pump(KB billet,16AN inlet from oil...
Thank you for the adresse!!
I solved my clearance problem :a local machine shop is making a new snout shell based on the bearing and seal diameters. This one will be...
Thanks a lot for infos ! Cyril
hello Jim! here is my bearing problem: a little time ago i decided to change the snout bearing as i felt it was a little "rough" when turned by...
Hi all! would anybody using a whipple screw blower tell me what snout bearing(and seal) they are using,and where to buy one? i thank you in...
