Separate names with a comma.
Nitrohawk, you are 100% correct. "Sprotsnationals" without The Top Alcohol cars is an insult to everyone that has poored so much effort into these...
The Plaza car? It makes the blower a rear discharge, (sort of). Helping to even out distribution. [ October 07, 2005, 01:45 AM: Message edited...
Get well soon George, you and Jane are in our prayers.
The pistons physical position in the bore is differant at the same point in the crankshafts rotation(degrees BTDC or ATDC) with a long vs. short...
There's only 360 degrees in a circle. If the piston is "parked" for more crankshaft degrees at TDC&BTC with a longer rod(which it is). Then the...
And therefore it travels faster between those two points. :eek:
You can call (616-669-7883) me at my shop on Tuesday. I'll be at The D3 race at Mid-Michigan the rest of the week. :D
Shakedown, I have several sanddrag customers that run the iron dart blocks with whipple r980's with as much as 60% over. We haven't had any main...
That's gettin' after it! :eek: [ June 21, 2005, 01:44 PM: Message edited by: rpmhiperf ]
Same here,slooooooww.
Didn't Jeff Wilson already attempt this on a limited basis?
I don't think it would be a good idea to start playing with a high speed until after you add port nozzels.
No, LT is no longer around. Try Bob at East West Clutch in Azusa CA. The Last phone number I have for them is 626-334-3710.
Gap your plugs down to .018 :D
The discs are marked but you have to look really close in the center hub area. (get your glasses out) Very small stamp or scribe will read 5135 or...
Not knowing your application it's hard to tell but, I would check your discs to see what you have. If you have 0 turns on the base now and aren't...
It's more about what your chamber looks like rather than your bore size. About 4.800" o.d. on the "o" ring groove. I know this sounds big but you...
Viva El Presidente' :cool:
When running an engine on the dyno, with a belt drive timing system (jesel,whoever). Have any of you guys ever watched the cam gear with a timing...
I know it's differant today with the fuel volumes that are run. But I can remember watching TF cars shaking {Connie Kalitta was one of them} hard...
