Separate names with a comma.
for the inside of the tubing I mist in boiled linseed Dont use raw linseed it will rust steel.
Is Scott Moore from Mooresville NC safe to buy off - I live on the otherside of the planet.
rod side clearance .058 sounds good if in doubt check out www.rrconnectingrods.com or grp they both support this site
treating methanol personally i treat mine with 100 mils of caster oil per 5 gallons of methanol. keep containers off concrete floor, on a pallet...
update Since this post, I received communication from Raul, he advises he was going to send them last week, so hopefully.
I bought some spares from a guy back in April 2011 he advised he lived at If any body knows him could you ask what is happening, as I live...
Is there a Hemi pattern bell housing to Bruno Drive out there?
adapting current mid plate, or manufacture new one If your planning to do this yourself: 1. Buy/scrounge a piece of pipe slightly larger in...
shim under sleeve Yes works perfect, i had some lazer cut, found stainless steel best. may pay to shim it up thicker than .008 as thats quite...
just called them thanks for this cheers
Who makes a 1 piece unit that runs 250 psi and 200 psi for shift and transbrake via same bottle? Trying to save running 2 separate regulators.
What effect will dropping the lift at cam from .465 down to .440? E.G. Will it allow engine to rev easier. Will it hurt performance....
looking at your later piks it does appear to show rubbed & or oil starved. dont the oil feeds for the lifters in the blocks run on the outer...
thanks kurt for you thoughts, for the past 18 years this was solved by using 1/4" 4130 on both and having the rr bracket outside of the chassis...
Why are the mounting brackets on a custom fabricated rear-end parallel to the wheels when nearly all rear engine dragster chassis' angle in from...
strip every thing off of it incl shaft bearings and take to an ali strip shop, they will dip all.
Liquid pipe sealant. A very light smear on the nozzle body thread. If you guys are stripping the threads, you are tightening up far too tight....
neck & helemt restraint has anybody had any experience with the isaac system
info quoted as per the venolia spec sheet that came with the rods i purchased direct from venolia, good news that you have contacted them directly.
