Separate names with a comma.
yes, if you feed it in through the pressure gauge hole. thanks heaps for the help and advice, thanks also to dean at dmp awnings, heading off...
No timing control
whats a good launch rpm, tad, bruno, B & J w / 1.51 low gear, screw hemi, 508ci, 10000 rpm +
stay set up the way you are, you likely may wreck your car, along with your opponent, not to mention physically and emotionally hurting lots of...
RPM All the way RPM 100% Car wouldnt fire, were at the track, called Randy as I'd had logger, coil, mag, points box and tach convertor out,...
more info what tyre size. what rear end ratio. what sort of power. what sort of rev range. tall and 2 speed is the new go with big hp,...
hunt increase the diameter of tank vent
slider gear removed the female slider gear, annealed it, filed a better lead on the edges of the splines, had it reheat treated, perfect as now.
What back space would be a likely minimum for a NT/F FED for say 16 x 10? What bolt pattern is recommended? I have a spare rear end...
tyres we keep lots of notes on our tyres, they are measured, pressures read, rotated, temps taken, time of day recorded etc etc, since doing this...
a custom hemi, was concerned the side load could cause probs sooner than later, thanks for your feedback, sounds like theres nothing to worry about
looking at straightening the pushrod angles up, a .180 offset would be real nice, is it worth the risk.
plugged mine into my 44 points box with rev limiter, I don't take fuel away, it works perfectly. I do have a 4 stage timer, not used. - randy...
plugs into an msd 6al and up ( 6al, we all on here and every one every where, trust your not using one of these still ), if your running a mag,...
Hi Mike Could you run a tape across the inside diameter - checking all directions and advise the opening. What mods have you made. Price...
Any body using one of these at all, I would like some hands on info especially about the 6046
washer sounds like the perfect solution, check each face is parallel, cost sounds awfully cheap also. If you have a dual regulator, you could...
40t 8mm pulley I have one, brand new psi made it for me, changed direction. check your pm
amps Thanks Ronny what sort of amps are you talking I should use.
First time user of Bruno, ready to go, hooked everything up, air on, pressed brake button. Air exhausts from brake unit, is this normal whilst...
