Separate names with a comma.
rod is great. talked to firm that ordered pistions, and researched this. pins likely flexing / bending - 1.094 as supplied with original pistons...
youngtuner: my new pistons have arrived I had to stipulate i wanted oil hole to pin boss - je advised they dont need them, i insisted - they did...
pm me your email
I read recently pro stock suffered this very problem - coated pins I believe doubled the life of the pistons. I want to overcome the issue and not...
tol:dont know what vacuum. mostly 50wt have used 70 on occassions. Both banks Jay: will get back to you on clearance, pistons are not coated....
Very, motor has 12 passes with rpm 8500 - everything else is perfect except pins, piston bosses and intake side of skirts. Pins have grooved...
I have done some research regarding getting oil to the wrist pins. Dry sump, full scrapers, sump lower than crank etc etc. New pistons now have...
No i haven't - reason being we are in the south pacific time zone and have, (at present its 7.22pm Sunday 1st Nov where as in California for...
with transmission removed - fluid is definately seeping along the splines of shaft between the drum splines and the shaft splines that the drum...
its weeping between the shaft and drum spline and dripping down between trans and bruno. i refilled the bruno after installing a new rear seal and...
What is best to use to seal the drum onto the shaft of the bruno to stop it seeping. I've narrowed it down to this after replacing the seal and...
auxillary battery to neutral and kill switch is it at all possible to run an onboard auxillary battery, thats wired to kill switch to neutral...
grid vs 8973 http://www.yellowbullet.com/forum/showthread.php?t=864018
Use a burst panel frame, machine a 1/4 bolt so the shaft fits into the frame holes - while machining make sure to machine a point on the end -use...
Bump to the top 500.00
lenco CS 2 gear set 1.41 35/32 spline -this is the large fine spline, pictures available. brand new 500.00 shipped.
you are not alone - bought a set of the 4" wide fronts 4 years ago - they cracked really bad - goodyear sent 1 replacement, its sidewall cracked...
10 to 15* works fine, the more degrees you use the greater the risk of a wheel "locking" rocking over whilst turning too tightly when pushing the...
I'm starting to notice some people running their blower mainfolds with a gasket not the oring. I asume their using graphite type gasket? Is...
bump to the top please
